|
MK3721 Datasheet, PDF (1/4 Pages) Integrated Circuit Systems – Low Cost 3.3 Volt VCXO | |||
|
I CR O C LOC K
MK3721
Low Cost 3.3 Volt VCXO
Description
The MK3721 is ICS/MicroClockâs lowest cost,
low jitter, high performance 3.3 volt VCXO
designed to replace expensive VCXO modules.
The on-chip Voltage Controlled Crystal Oscillator
accepts a 0 to 3.3 V input voltage to cause the
output clocks to vary by ±100 ppm. Using
ICS/MicroClockâs patented VCXO techniques,
the device uses an inexpensive external pullable
crystal in the range of 16.2 - 28 MHz to produce a
VCXO output clock at that same frequency.
ICS/MicroClock manufactures the largest variety
of Set-Top Box and multimedia clock synthesizers
for all applications. If more clock outputs are
needed, see the MK3732 or MK377x family of
parts. Consult ICS/MicroClock to eliminate
VCXOs, crystals and oscillators from your board.
Features
⢠Packaged in 8 pin SOIC
⢠3.3 V operating voltage
⢠16.2 MHz to 28 MHz operation
⢠Uses an inexpensive external crystal
⢠On-chip VCXO (patented) with pull range of
200 ppm (minimum)
⢠VCXO tuning voltage of 0 to 3.3 V
⢠12 mA output drive capability at TTL levels
⢠Advanced, low power, sub-micron CMOS process
⢠For frequencies between 8 MHz to 16 MHz, use
the MK3711A. For frequencies between 1 MHz
and 8 MHz, use the MK3713. For higher than
28 MHz, use the MK3732-05
Block Diagram
VIN
X1
16.2 -28 MHz
pullable crystal
X2
Voltage
Controlled
Crystal
Oscillator
Output
Buffer
16.2 - 28 MHz Clock
(REFOUT)
MDS 3721 B
1
Revision 082800
Integrated Circuit Systems, Inc. ⢠525 Race Street ⢠San Jose â¢CA ⢠95126⢠(408)295-9800tel ⢠www.icst.com
|
▷ |