|
M675 Datasheet, PDF (1/6 Pages) Integrated Circuit Systems – VOLTAGE CONTROLLED SAW OSCILLATOR | |||
|
Integrated
Circuit
Systems, Inc.
Preliminary Information
M675
VOLTAGE CONTROLLED SAW OSCILLATOR
GENERAL DESCRIPTION
The M675 is a VCSO (Voltage Controlled SAW
Oscillator) frequency source for low-jitter
clock generation. An integrated SAW
(surface acoustic wave) delay line
implements the high-Q VCO (voltage
controlled oscillator) function, which
results in low output phase noise and very low jitter.
The M675-01 is available in a range of center
frequencies from 125 to 175 MHz. The M675-02
provides 500 to 700 MHz. Guaranteed minimum
pull-range of ±100 ppm meets GbE requirements.
(It also fully satisfies ±50 ppm minimum pull-range
specification commonly required.) Industry-standard
Kvco (VCO Gain) provides full replacement compati-
bility. The M675 is well suited for phase-locked loop
implementations, clock and data recovery circuits, and
other timing applications in telecom and optical fiber
networking systems (e.g., SONET/SDH).
FEATURES
â Integrated SAW device
â M675-01 output frequencies from 125 to 175 MHz
M675-02 output frequencies from 500 to 700 MHz
(Specify center frequency at time of order)
â Industry-standard Kvco for full compatibility
â Low phase jitter 0.2ps rms typical for the M675-02
(50kHz to 80MHz)
â Differential 3.3V LVPECL output
â Single 3.3V power supply
â Small 5 x 7.5mm SMT (surface mount) package
BLOCK DIAGRAM
MM667705
PIN ASSIGNMENT (5 x 7.5mm SMT)
M67755
(Top View)
Figure 1: Pin Assignment
Sample of Available Output Frequencies
VCSO Center Frequencies1 (MHz)
M675-01
M675-02
Applications
155.5200
622.0800
SONET/SDH
156.2500
625.0000
Gigabit Ethernet
161.1328
644.5313 Gigabit Ethernet FEC
167.3316
669.3266
SONET/SDH FEC
Table 1: Sample of Available Output Frequencies
Note 1: Specify VCSO center frequencies at time of order
VIN
CLK_EN
SAW Delay Line
Phase
Shifter
FOUT
nFOUT
Figure 2: Block Diagram
M675 Datasheet Rev 0.4
Revised 16Nov2004
M675 Voltage Controlled SAW Oscillator
Integrated Circuit Systems, Inc. â Networking & Communications â www.icst.com â tel (508) 852-5400
|
▷ |