X24026 Datasheet, PDF (9/15 Pages) Xicor Inc. – Serial E2PROM

X24026
ABSOLUTE MAXIMUM RATINGS*
Temperature Under Bias...................–65°C to +135°C
Storage Temperature ........................ –65°C to +150°C
Voltage on any Pin with
Respect to V _SS ............................. –1.0V to +7.0V
D.C. Output Current .............................................5 mA
Lead Temperature (Soldering, 10 Seconds) ...... 300°C
*COMMENT
Stresses above those listed under “Absolute Maximum
Ratings” may cause permanent damage to the device.
This is a stress rating only and the functional operation of the
device at these or any other conditions above those
indicated in the operational sections of this specification is
not implied. Exposure to absolute maximum rating
conditions for extended periods may affect device reliability.
RECOMMENDED OPERATING CONDITIONS
Temperature
Min.
Max.
Commercial
0°C
70°C
7020 FRM T09
Supply Voltage
X24026
X24026-2.7
Limits
4.5V to 5.5V
2.7V to 5.5V
7020 FRM T10
D.C. OPERATING CHARACTERISTICS (Over recommended operating conditions unless otherwise specified).
Limits
Symbol
Parameter
Min.
Max. Units
Test Conditions
l_CC1
l_CC2
I_SB ⁽¹⁾
Power Supply Current (read)
Power Supply Current (write)
Standby Current
1
mA
SCL = V_CC x 0.1/V _{CC x 0.9 Levels @}
2
100 KHz, SDA = Open
50
∝A
SCL = SDA = V_CC – 0.3V, V_CC
= 5V ±10%
I_SB ⁽²⁾
I_LI
I_LO
Standby Current
Input Leakage Current
Output Leakage Current
30
∝A _{SCL = SDA = VCC – 0.3V, VCC = 3V}
10
∝A
V_IN = GND to V_CC
10
∝A
V_OUT = GND to V_CC
V_lL ⁽²⁾
Input Low Voltage
–1.0
V_CC x 0.3
V
V_IH ⁽²⁾
Input High Voltage
V_CC x 0.7 V_CC + 0.5
V
V_OL
Output Low Voltage
0.4
V
I_OL = 3 mA
7020 FRM T02
CAPACITANCE T_A = 25°C, f = 1 MHz, V_CC = 5V
Symbol
Parameter
C_I/O ⁽³⁾
Input/Output Capacitance (SDA)
C_IN ⁽³⁾
Input Capacitance (SCL)
Notes:(1)Must perform a stop command prior to measurement.
(2)VIL min. and VIH max. are for reference only and are not tested. (3)This
parameter is periodically sampled and not 100% tested.
Max.
8
6
Units
pF
pF
Test Conditions
V_I/O = 0V
V_IN = 0V
7020 FRM T04
9