X24012 Datasheet, PDF (9/14 Pages) Xicor Inc. – Serial E2PROM

X24012
ABSOLUTE MAXIMUM RATINGS*
Temperature Under Bias .................. –65°C to +135°C
Storage Temperature ....................... –65°C to +150°C
Voltage on any Pin with
Respect to V _SS ............................... –1.0V to +7V
D.C. Output Current ............................................ 5 mA
Lead Temperature (Soldering,
10 Seconds)
............................. 300°C
*COMMENT
Stresses above those listed under “Absolute Maximum
Ratings” may cause permanent damage to the device.
This is a stress rating only and the functional operation of the
device at these or any other conditions above those
indicated in the operational sections of this specification is
not implied. Exposure to absolute maximum rating condi-
tions for extended periods may affect device reliability.
RECOMMENDED OPERATING CONDITIONS
Temperature
Min.
Max.
Supply Voltage
Limits
Commercial
0°C
70°C
X24012
4.5V to 5.5V
Industrial
–40°C
+85°C
X24012-3
3V to 5.5V
Military
–55°C
+125°C
X24012-2.7
2.7V to 5.5V
3847 PGM T02
3847 PGM T03
D.C. OPERATING CHARACTERISTICS (Over recommended operating conditions unless otherwise specified)
Symbol
Parameter
l_CC1 Power Supply Current (Read)
Limits
Min.
Max.
1
l_CC2 Power Supply Current (Write)
2
I_SB(1) Standby Current
50
I_SB(2) Standby Current
30
I_LI
I_LO
V_lL(2)
V _IH(2)
V_OL
Input Leakage Current
Output Leakage Current
Input Low Voltage
Input High Voltage
Output Low Voltage
–1.0
V_CC x 0.7
10
10
V_CC x 0.3
V_CC + 0.5
0.4
Units
Test Conditions
mA _{SCL = VCC x 0.1/VCC x 0.9 Levels @ 100}
KHz, SDA = Open, All Other
Inputs = GND or V_CC – 0.3V
∝A _{SCL = SDA = VCC – 0.3V, All Other}
Inputs = GND or V_CC, V_CC = 5.5V
∝A _{SCL = SDA = VCC – 0.3V, All Other}
Inputs = GND or V_CC, V_CC= 3V
∝A _{VIN = GND to VCC}
∝A _{VOUT = GND to VCC}
V
V
V I_OL = 3 mA
3847 PGM T04
CAPACITANCE T_A = 25°C, F = 1.0MHZ, V_CC = 5V
Symbol
Test
C (3)
I/O
C_IN(3)
Input/Output Capacitance (SDA)
Input Capacitance (A₀, A₁, A₂, SCL, WC)
Notes:(1) Must perform a stop command prior to measurement. (2)
V _IL min. and V_{IH max. are for reference only and are not tested. (3)}
This parameter is periodically sampled and not 100% tested.
Max.
8
6
Units
pF
pF
Conditions
V_I/O = 0V
V_IN = 0V
3847 PGM T06
9