English
Language : 

IC-JE Datasheet, PDF (1/9 Pages) IC-Haus GmbH – PWM RELAY/SOLENOID DRIVER
iC-JE
PWM RELAY/SOLENOID DRIVER
FEATURES
o Wide operating voltage range of 10 to 45 Vdc
o PWM control for coil currents of 40 to 300 mA
o Coil current for energise and hold modes set by an external
resistor
o Coil current monitored during energise mode, detection of load
breakage and voltage errors
o Automatic current reduction after 100 ms to reduce the power
consumption in hold mode
o The internal free-wheeling alteration function supports PWM
operation and quick demagnetising during shutdown
o Status signalled at the current-limited LED output
o Shutdown with excessive temperature and low voltage
o Integrated oscillator needs no external components
o PWM frequency is beyond audible range
o Protective circuitry against damage by ESD
o Minimum space requirements, few external components
Rev F1, Page 1/9
APPLICATIONS
o PWM drive for inductive loads
(e.g. relays, electrovalves)
o Relay low-/high-side switch
PACKAGES
SO8
PDIP8
BLOCK DIAGRAM
10...45 V
LOW VOLTAGE
ERR
THERMAL SHUTDOWN
1 LED
INI
HOLD
MUX
ON
2.4 Hz
OFF
3 IN
INI
INPUT
iC−JE
TURN−ON CURRENT
CONTROL
EN
HOLD MODE
DELAY
START
t >= 100 ms
TURN−ON
RESET
t = 25 us
PWMOK
SQ
R
HOLD
REFERENCE
+
−
x1.0
x0.66
0
MUX
1
1.2 V
ISET
2
RSET
10...60 kΩ
DRIVER OUTPUT
VB 8
15 V
I
V
−+
PWM
CONTROL
80 kHz
PWMOK
OUT 7
LOUT
0.01...10 H
GND 6
GND
Copyright © 2007 iC-Haus
http://www.ichaus.com