GMS87C1102 Datasheet, PDF (51/80 Pages) Hynix Semiconductor – CMOS SINGLE-CHIP 8-BIT MICROCONTROLLER

HYUNDAI MicroElectronics
GMS87C1102 / GMS87C1202
ADCM
ADCR
A/D Control Register
-
-
ADEN
ADS2
ADS1
ADS0
ADST
ADSF
ADDRESS : EAH
RESET VALUE : --000001
Reserved
Analog Channel Select
000 : Channel 0 ( RB0/AN0 )
001 : Channel 1 ( RA1/AN1 )
010 : Channel 2 ( RA2/AN2 )
011 : Channel 3 ( RA3/AN3)
100 : Channel 4 ( RA4/AN4 )
101 : Channel 5 ( RA5/AN5 )
110 : Channel 6 ( RA6/AN6 )
111 : Channel 7 ( RA7/AN7 )
A/D Status bit
0 : A/D Conversion is in process
1 : A/D Conversion is completed
A/D Start bit
1 : A/D Conversion is started
After 1 cycle, cleared to "0"
0 : Bit force to zero
A/D Result Data Register
A/D Enable bit
1 : A/D Conversion is enable
0 : A/D Converter module shut off
and consumes no operation current
ADCR7 ADCR6 ADCR5 ADCR4 ADCR3 ADCR2 ADCR1 ADCR0
ADDRESS : EBH
RESET VALUE : Undefined
ENABLE A/D CONVERTER
A/D INPUT CHANNEL SELECT
ANALOG REFERENCE SELECT
A/D START ( ADST = 1 )
NOP
Figure 17-2 A/D Converter Registers
A/D Converter Cautions
(1) Input range of AN0 to AN7
The input voltages of AN0 to AN7 should be within the
specification range. In particular, if a voltage above VDD
(or AVref) or below VSS is input (even if within the absolute max-
imum rating range), the conversion value for that channel can not
be indeterminate. The conversion values of the other channels
may also be affected.
(2) Noise countermeasures
In order to maintain 8-bit resolution, attention must be paid to
noise on pins AVref(or VDD)and AN0 to AN7. Since the effect
increases in proportion to the output impedance of the an-
alog input source, it is recommended that a capacitor be con-
nected externally as shown in Figure 17-4 in order to reduce
noise
.
ADSF = 1
NO
YES
READ ADCR
Analog
Input
100~1000pF
AN0~AN7
Figure 17-3 A/D Converter Operation Flow
Figure 17-4 Analog Input Pin Connecting Capacitor
Oct. 1999 ver 1.0
51