MS8607 Datasheet, PDF (3/12 Pages) TE Connectivity Ltd – Digital Pressure and Humidity Sensor

MEAS MS8607 DCS FOR ZedBoard
Digital Pressure and Humudity Sensor
 USB-to-microUSB cable for UART communications
 A computer with a card reader to write to the SD card and to host a terminal emulator
The following steps will guide you through setting up the hardware platform:
1. First, if you have not connected your computer to a ZedBoard or MicroZed device before, you will likely need to download
and install the Silicon Labs CP2104 USB-to_UART driver. The setup guide for installing the driver can be found at the
address below: http://www.zedboard.org/sites/default/files/documentations/CP210x_Setup_Guide_1_2.pdf
2. Next, attach the SD card to your computer via a card reader or through the built-in SD card slot. Download the “boot.bin”
file that pertains to the MS5637 from the software link and copy it onto the SD card so that it is the only file present on the
file system.
3. Safely eject the SD card from your computer. Insert the SD card into the card slot on the back of the ZedBoard.
ZedBoard, MicroZed and Digilent Pmod™ are trademarks.
4. Connect the MS8607 digital pressure sensor to the “JC” Digilent Pmod™ port of the ZedBoard (1), ensure that jumpers
JP7, JP8, JP9, JP10, and JP11 are configured such that the ZedBoard will boot from the SD card on start-up (2), and
3
4
2
SENSOR SOLUTIONS /// MEAS MS8607 DCS DEVELOPMENT KIT
1
2
07/2016
Page 3