H7806AM Datasheet, PDF (1/3 Pages) Hi-Sincerity Mocroelectronics – Low Current Positive Voltage Regulator Of Surface Mount Device

HI-SINCERITY
MICROELECTRONICS CORP.
Spec. No. : HM200104
Issued Date : 2001.10.01
Revised Date : 2001.10.11
Page No. : 1/3
H7806AM
H7806BM
Low Current Positive Voltage Regulator Of Surface Mount Device
Description
The H7806_M series of surface mount device regulators are easy-to-use
SOT-89
devices suitable for multitude of applications that require a regulated supply
of up to 100mA. These regulators feature internal current limiting and thermal shutdown making them
remarkably rugged. No external components are required with the H7806_M devices in many applications.
These devices offer a substantial performance advantage over the traditional zener diode resistor
combination, as output impedance and quiescent current are substantially reduced.
• Wide Range Of Available, Fixed Output Voltages
• Internal Short-Circuit Current Limiting
• Internal Thermal Overload Protection
• No External Components Required
Absolute Maximum Ratings (Ta=25°C)
• Input Voltage ...................................................................................................................................... 35 V
• Total Power Dissipation................................................................................................... Internally limited
• Operating Temperature Range ........................................................................................ 0 °C to +125 °C
• Maximum Junction Temperature.................................................................................................... 125 °C
• Storage Temperature Range......................................................................................... -55 °C to +150 °C
• Lead Temperature (Soldering 10S)................................................................................................ 260 °C
Typical Application
Schematic Diagram
Vin
Vout
3 _{H7806_M} 1
2
C1
C2
A common ground is required between the input
and the output voltages. The input voltage must
remain typically 2.0V above the output voltage even
during the low point on the input ripple voltage.
Note : C1 and C2 are required if regulator is located
far from power supply filter and load, or oscillation
may induced on the loop.
576
3.41K
3.89K
7.8K
Vin
5K
5.7K
100
100
5pF
1.5K 1.9K
Vout
13K
2.23K
2.84K
GND
H7806AM, H7806BM
HSMC Product Specification