81663A Datasheet, PDF (3/5 Pages) Agilent(Hewlett-Packard) – DFB Laser Fabry-Perot Lasers

Technical Specifications
Fabry-Perot source module specifications
(high-power modules, 13 dBm)
Specifications apply to the end of a 2 m long fiber cable (as specified under fiber
type) with Diamond® HMS-10/Agilent connectors attached. All specifications
are valid for an attenuation setting of 0.0 dB. All modules require straight output
connectors.
Type
Center wavelength¹
Fiber type
Spectral bandwidth
(rms) ^{1, 2}
Output power
Agilent
81655A
Agilent
81656A
Fabry-Perot Laser
Agilent
81657A
1310 nm
±15 nm
1550 nm
±15 nm
1310/1550 nm
± 15 nm
Standard single-mode 9/125 µm
< 5.5 nm
< 7.5 nm
< 5.5nm/7.5 nm
> +13 dBm (20 mW)
CW power stability ^{3, 4}
Short term
(15 minutes)
< ± 0.005 dB
Typical < ±0.003 dB with coherence control active
Long term (24 hours)
Typical ± 0.03 dB
To back reflection
(RL ≥ 14 dB)
Typical ± 0.003 dB
Supplementary
Performance
Specifications
Internal digital
modulation mode
270 Hz, 330 Hz, 1 kHz, 2 kHz
and free selection 200 Hz to 10 kHz.
All output signals are pulse shaped,
duty cycle 50%.
Internal coherence control for line-
width broadening.
Output attenuation
The output power of all source mod-
ules can be attenuated from 0 dB to
6 dB in steps of 0.1 dB.
Laser safety information
All laser sources listed above are
classified as Class 1M according to
IEC 60825 1 (2001). All laser sources
comply with 21 CFR 1040.10 except
for deviations pursuant to Laser
Notice No. 50, dated 2001-July-26.
Dimensions
(H x W x D)
Weight
Recalibration period
Operating temperature
Humidity
Warm-up time
75 mm x 32 mm x 335 mm (2.8” x 1.3” x 13.2”)
0.5 kg
2 years
0 ºC to 45 ºC
Non-condensing
60 minutes³
Table 2. Technical specifications for Fabry-Perot source modules (high-power
modules, 13 dBm)
1. Center wavelength is shown on display
2. RMS: root mean square
3. Warm-up time 20 min, if previously stored at the same temperature.
4. Controlled environment (∆T = ± 1 °C)
INVISIBLE LASER RADIATION
DO NOT VIEW DIRECTLY WITH
OPTICAL INSTRUMENTS
CLASS 1M LASER PRODUCT
(IEC 60825-1 / 2001)
Figure 2. Laser classification label for Class 1M
3