HCPL-M700 Datasheet, PDF (2/8 Pages) Agilent(Hewlett-Packard) – Small Outline, 5 Lead, Low Input Current, High Gain Optocouplers

2
The HCPL-M701 is for use in
CMOS, LSTTL or other low power
applications. A 400% minimum
current transfer ratio is
guaranteed over a 0-70°C
operating range for only 0.5 mA
of LED current.
The HCPL-M700 is designed for
use mainly in TTL applications.
Current Transfer Ratio is 300%
minimum over 0-70°C for an LED
current of 1.6 mA [1 TTL Unit
Load (U.L.)]. A 300% CTR
enables operation with 1 U.L. out
with a 2.2 kΩ pull-up resistor.
Selection for lower input currents
down to 250 µA is available upon
request.
Outline Drawing (JEDEC MO-155)
Applications
• Ground Isolate Most Logic
Families - TTL/TTL, CMOS/
TTL, CMOS/CMOS, LSTTL/
TTL, CMOS/LSTTL
• Low Input Current Line
Receiver
• EIA RS232C Line Receiver
• Telephone Ring Detector
• ac Line Voltage Status
Indicator - Low Input
Power Dissipation
• Low Power Systems -
Ground Isolation
4.4 ± 0.1
(0.173 ± 0.004)
MXXX
XXX
ANODE 1
7.0 ± 0.2
(0.276 ± 0.008)
CATHODE 3
6 V_CC
5 V_OUT
4 GND
0.4 ± 0.05
(0.016 ± 0.002)
3.6 ± 0.1*
(0.142 ± 0.004)
2.5 ± 0.1
(0.098 ± 0.004)
0.102 ± 0.102
(0.004 ± 0.004)
1.27 _BSC
(0.050)
(00..07218)MIN.
DIMENSIONS IN MILLIMETERS (INCHES)
* MAXIMUM MOLD FLASH ON EACH SIDE IS 0.15 mm (0.006)
NOTE: FLOATING LEAD PROTRUSION IS 0.15 mm (6 mils) MAX.
0.15 ± 0.025
(0.006 ± 0.001)
7° MAX.
MAX. LEAD COPLANARITY
= 0.102 (0.004)
Land Pattern Recommendation
4.4
(0.17)
2.5
(0.10)
1.3
(0.05)
2.0
(0.080)
8.27
(0.325)
0.64
(0.025)
Schematic
+ ^IF
ANODE
1
V_F
–
CATHODE
3
6
V_CC
I_CC
I_{O 5}
V_O
4
GND