FS2100 Datasheet, PDF (16/48 Pages) Agilent(Hewlett-Packard) – LOCAL BUS

Setting up the
Analyzer from the
diskette
Logic Analyzer
166x
166x
166x
16550A
16550A
16550A
16550A
16550A
1655x,167x
The logic analyzer can be configured for PCI analysis by loading
the PCI configuration file. Loading this file will load the PCI Local
bus inverse assembler and configure your logic analyzer. To
load the configuration and inverse assembler:
1. Install the PCI Active Analysis Probe software flexible
diskette in the disk drive of the logic analyzer.
2. Configure the menu to “Load” the analyzer with the
appropriate configuration file (see table below).
3. Execute the load operation to load the file into the logic
analyzer that the PCI Active Analysis Probe module is
connected to. DO NOT SELECT ALL OR SYSTEM.
File
nam
e for
State
Anal
ysis
Comment
P32M_66 32 bit Multiplexed - Analysis Probe PODS 1-4
0
connect to Logic Analyzer PODS 1-4
P32D_66 32 bit Demultiplexed - Analysis Probe PODS
0
1-6 connect to Logic Analyzer PODS 1-6
P64M_66 64-bit Multiplexed- Analysis Probe PODS 1-
0
4,7,8,11 to Logic Analyzer PODS 1-7
P32M_55 32 bit Multiplexed- Analysis Probe PODS 1-4
0
connect to Logic Analyzer PODS 1-4
P32D_55 32 bit Demultiplexed - Analysis Probe PODS
0
1-6 connect to Logic Analyzer PODS 1-6
P64AD55
0
32 bit address Demultiplexed and 64 bit data
Analysis Probe PODS 1-6,7,8 and 11
connect to Logic Analyzer PODS 1-6 on
the Master card and 1-3 on the Slave card
respectively.
P64M_55
0
64-bit Multiplexed - Analysis Probe PODS 1-
4,7,8,11 connect to LA PODS 1-6 on the
Master card and Pod 1 on the Slave card
respectively
P64D_55
0
64 bit Demultiplexed- Analysis Probe PODS 1-
11 connect to Logic Analyzer PODS 1-6
on the Master card and PODS 1-5 on the
Slave Card respectively
P32M_55 32 bit Multiplexed - Analysis Probe PODS 1-4
5
connect to Logic Analyzer PODS 1-4
16