HPDL-1414 Datasheet, PDF (12/12 Pages) Agilent(Hewlett-Packard) – Four Character Smart Alphanumeric Displays

Soldering and Post Solder
Cleaning Instructions
The HPDL-1414/2416 may be
hand soldered or wave soldered
with SN63 solder. Hand soldering
may be safely performed only
with an electronically
temperature-controlled and
securely grounded soldering iron.
For best results, the iron tip
temperature should be set at
315°C (600°F). For wave
soldering, a rosin-based RMA flux
can be used. The solder wave
temperature should be
245°C ± 5°C (473°F ± 9°F),
and the dwell in the wave should
be set at 1¹/2 to 3 seconds for
optimum soldering. Preheat
temperature should not exceed
93°C (200°F) as measured on the
solder side of the PC board.
For further information on
soldering and post solder
cleaning, see Application Note
1027, Soldering LED
Components.
3-186