HSSR-8400 Datasheet, PDF (1/13 Pages) Agilent(Hewlett-Packard) – 400 V/10 Ohm, General Purpose, 1 Form A, Solid State Relay

H
400 V/10 Ohm,
General Purpose, 1 Form A,
Solid State Relay
Technical Data
HSSR-8400
Features
• Compact Solid-State
Bidirectional Switch
• Normally-Off Single-Pole
Relay Function (1 Form-A)
• 400 V Output Withstand
Voltage in Both Polarities at
25°C
• 150/300 mA Current Ratings
(See Schematic for
Connection A & B)
• Low Input Current; CMOS
Compatibility
• Very Low On-Resistance: 6 Ω
Typical at 25°C
• ac/dc Signal & Power
Switching
• Input-to-Output Momentary
Withstand Insulation
Voltage: 2500 Vac, 1 Minute
• 16-kV ESD Immunity: MIL-
STD-883, Method 3015
• CSA Approved
• UL 508 Recognized
Applications
• Modems
• Telecommunication
Switching Equipment
• Telecommunication Test
Instruments
• Reed Relay Replacement
• 110/220 Vac Load Driver
• Industrial Relay Coil Driver
Description
The HSSR-8400 consists of a
high-voltage circuit, optically
coupled with a Light-Emitting
Diode (LED). This device is a
solid-state replacement for single-
pole, normally-open (1 Form A)
electromechanical relays used for
general purpose switching of
signals and low-power ac/dc
loads. The relay turns on (contact
closes) with a minimum input
current, I_F, of 5 mA through the
input LED. The relay turns off
(contact opens) with an input
voltage, V_F, of 0.8 V or less. The
detector contains a high speed
photosensitive FET driver circuit
and two high voltage MOSFETs.
This relay’s logic-level input con–
trol and very low typical output
on-resistance of 6 Ω make it
suitable for switching of audio
frequency signals in telecom
applications. Connection A, as
shown in the schematic, allows
the relay to switch either ac or dc
loads. In this configuration, the
150 mA output current rating
allows it to switch small loads
that are driven from 110 Vac and
220 Vac power lines. Connection
B, with the polarity and pin
configuration as indicated in the
schematic, allows the relay to
switch dc loads only. The
advantage of Connection B is that
the on-resistance is significantly
reduced and the output current
capability increases by a factor of
two.
The electrical and switching
characteristics of the HSSR-8400
are specified from -40°C to
+85°C.
Functional Diagram
TRUTH TABLE
(POSITIVE LOGIC)
LED OUTPUT
ON
L
OFF
H
CAUTION: It is advised that normal static precautions be taken in handling and assembly of this component to
prevent damage and/or degradation which may be induced by ESD.
5965-3573E
1-465