HSSR-8200 Datasheet, PDF (1/11 Pages) Agilent(Hewlett-Packard) – 200-V/160 Ohm, 1 Form A, Small-Signal Solid State Relay

H
200-V/160 Ohm, 1 Form A,
Small-Signal Solid State Relay
Technical Data
HSSR-8200
Features
• Compact Solid-State
Bidirectional Signal Switch
• Normally-Off Single-Pole
Relay Function (1 Form A)
• Very High Output Off-
Impedance: 10,000
Gigaohms Typical at 25°C
• Very Low Output Offset
Voltage: < 0.5 µV at
I_F = 1 mA
• 200-Volt Output Withstand
Voltage at 25°C
• High-Transient Immunity:
> 2000 V/µs
• Monolithic High-Voltage IC
• Operating Range: -40°C to
+85°C
• Very Low Input Current
(1 mA); CMOS Compatibility
• High-Speed Switching: 50 µs
Typical
• 160-Ohm Maximum On-
Resistance at 25°C
• Surface Mount Option
• 8-kV ESD Immunity: MIL-
STD-883 Method 3015
• Input-to-Output Insulation
Voltage: 2500 Vac, 1 Minute
• UL 508 Recognized
• CSA Approved
Applications
• Relay Scanners & Analog
Input Modules of Data
Acquisition Systems
• Analog Input Modules of
Programmable Logic
Controllers
• Relay Multiplexers of High-
Performance Voltmeters
• Telecommunication Test
Instruments
• Functional Tester of Board
Test Equipment
• Analog Signal Multiplexer
• Flying Capacitor Multiplexer
• Reed Relay Replacement
Functional Diagram
Description
The HSSR-8200 consists of a high-
voltage integrated circuit optically
coupled with a light emitting diode.
This device is a solid-state
replacement for single-pole,
normally-open electromechanical
relays used for general purpose
switching of analog signals.
The light-emitting diode controls
the ON/OFF function of the solid-
state relay. The detector contains
high voltage MOS transistors and a
high speed photosensitive drive
circuit. This relay has superior OFF
impedance, very low output offset
voltage and input drive current.
TRUTH TABLE
(POSITIVE LOGIC)
LED
ON
OFF
OUTPUT
L
H
CAUTION: It is advised that normal static precautions be taken in handling and assembly of this component to
prevent damage and/or degradation which may be induced by ESD.
1-454
5965-3574E