|
HCPL-050L Datasheet, PDF (1/11 Pages) Agilent(Hewlett-Packard) – LVTTL/LVCMOS Compatible 3.3 V Optocouplers (1 Mb/s) | |||
|
Agilent HCPL-250L/ 050L/253L/053L
LVTTL/LVCMOS Compatible 3.3 V
Optocouplers (1 Mb/s)
Data Sheet
Description
These diode-transistor optocouplers
use an insulating layer between a
LED and an integrated
photodetector to provide electrical
insulation between input and
output. Separate connections for
the photodiode bias and output-
transistor collector increase the
speed up to a hundred times that of
a conventional phototransistor
coupler by reducing the base-
collector capacitance.
These optocouplers are available
in an 8-pin DIP and in an industry
standard SO-8 package. The
following is a cross reference
table listing the 8-pin DIP part
number and the electrically
equivalent SO-8 part number.
The SO-8 does not require
"through holes" in a PCB. This
package occupies approximately
one-third the footprint area of the
Functional Diagram
HCPLâ250L/HCPLâ050L
NC 1
8 VCC
ANODE 2
7 VB
CATHODE 3
6 VO
NC 4
5 GND
HCPLâ253L/HCPLâ053L
ANODE 1 1
8 VCC
CATHODE 1 2
7 VO1
CATHODE 2 3
6 VO2
ANODE 2 4
5 GND
Features
⢠Low power consumption
⢠High speed: 1 Mb/s
⢠LVTTL/LVCMOS compatible
⢠Available in 8-pin DIP, SO-8
⢠Open collector output
⢠Guaranteed performance from
temperature: 0ËC to +70ËC
⢠Safety approval, UL, CSA, IEC/EN/DIN
EN 60747-5-2
Applications
⢠High voltage insulation
⢠Video signal isolation
⢠Power translator isolation in motor
drives
⢠Line receivers
⢠Feedback element in switched mode
power supplies
⢠High speed logic ground isolation â
LVTTL/LVCMOS
⢠Replaces pulse transformers
⢠Replaces slow phototransistor
isolators
⢠Analog signal ground isolation
TRUTH TABLE
(POSITIVE LOGIC)
LED
VO
ON
LOW
OFF HIGH
A 0.1 µF bypass capacitor must be connected between pins 5 and 8.
CAUTION: It is advised that normal static precautions be taken in handling and assembly of this component to prevent
damage and/or degradation which may be induced by ESD.
|
▷ |