HB916.5 Datasheet, PDF (3/3 Pages) –

Two-port SAW Resonator
7.Performance
7-1.Maximum Ratings
Rating
CW RF Power Dissipation
DC Voltage Between Terminals
Storage Temperature Range
Operating Temperature Range
Value
P
10
VDC
30
Tstg
-40 to +85
TA
-10 to +60
Unit
dBm
V
Â¥
Â¥
HB916.5
7-2.Electronic Characteristics


Characteristics
Center Frequency ^{Absolute Frequency}
(+25Â¥)
Tolerance from 916.500 MHz
Insertion Loss
Quality Factor
Unloaded Q
50 Ω Loaded Q
Temperature
Stability
Turnover Temperature
Turnover Frequency
Frequency Temperature Coefficient
Frequency Aging Absolute Value during the First Year
DC Insulation Resistance Between Any Two Terminals
Motional Resistance
RF Equivalent
RLC Model
Motional Inductance
Motional Capacitance
Shunt Static Capacitance
Sym
f_C
∆f_C
IL
Q_U
Q_L
T₀
f₀
FTC
|f_A|
R_M
L_M
C_M
C₀
Minimum
916.350
25
1.0
2.30
Typical
150
6.5
6,650
3,500
fc
0.032
›10
111.35
128.5222
0.2349
2.55
Maximum
916.650
9.0
Unit
MHz
kHz
dB
55
Â¥
kHz
ppm/Â¥²
ppm/yr
MΩ
182
Ω
µH
fF
2.80
pF
LCAUTION: Electrostatic Sensitive Device. Observe precautions for handling!
¯^{C 2003. All Rights Reserved.}
1. The frequency f_C is the frequency of minimum IL with the resonator in the specified test fixture in a 50Ȥ test
system with VSWR›1.2:1.
2. Unless noted otherwise, case temperature T_C = +25°C±2°C.
3. Frequency aging is the change in f_C with time and is specified at +65°C or less. Aging may exceed the
specification for prolonged temperatures above +65°C. Typically, aging is greatest the first year after manufacture,
decreasing in subsequent years.
4. Turnover temperature, T₀, is the temperature of maximum (or turnover) frequency, f₀. The nominal frequency at
any case temperature, T_C, may be calculated from: f = f₀ [1 - FTC (T₀ - T_C)²].
5. This equivalent RLC model approximates resonator performance near the resonant frequency and is provided for
reference only. The capacitance C₀ is the measured static (nonmotional) capacitance between input terminal and
ground or output terminal and ground. The measurement includes case parasitic capacitance.
6. Derived mathematically from one or more of the following directly measured parameters: f_C, IL, 3 dB bandwidth, f_C
versus T_C, and C₀.
7. The specifications of this device are based on the test circuit shown above and subject to change or
obsolescence without notice.
8. Typically, equipment utilizing this device requires emissions testing and government approval, which is the
responsibility of the equipment manufacturer.
9. Our liability is only assumed for the Surface Acoustic Wave (SAW) component(s) per se, not for applications,
processes and circuits implemented within components or assemblies.
10. For questions on technology, prices and delivery, please contact our sales offices or e-mail [e-mail].
Tel:[phone] Fax:[phone] E-mail: [e-mail] http://www.hoperf.com