HI-8200 Datasheet, PDF (1/10 Pages) Holt Integrated Circuits – Quad 10 Ohm 12V outside-the-rails Analog Switch with

December 2012
HI-8200, HI-8201, HI-8202
Quad 10 Ohm +/-12V outside-the-rails
Analog Switch with
Open Circuit when Power Off
GENERAL DESCRIPTION
The HI-8200 is a quad analog CMOS switch fabricated with Sili-
con-on-Insulator (SOI) technology for latch-up free operation
and maximum switch isolation. High voltage gate drive is en-
tirely created on-chip enabling +/-12V switching range from a
single 3.3V or 5V supply. These switches are ideally suited for
applications demanding low switch leakage when the power
pins are 0V.
At 25°C and with VDD from 3.0V to 5.5V, the switch resistance
(RON) is typically 8W. RON is independent of VDD. In a switch-
ing range of -5V to +5V, the maximum deviation of RON from
flat is less than 5%.
These switches conduct equally well in either direction. Power
down and Off state leakages are less than 10nA maximum.
Charge injection is less than 10pC. Switching times are typi-
cally 180ns to the On state and 60ns to the Off state. The on-
board charge pump allows an On/Off cycle time of 5KHz for all
four switches simultaneously before the switching range be-
comes restricted.
The HI-8200 provides four each normally open switches when
the switch control inputs are low. The HI-8201 provides four
each normally closed switches when the switch control inputs
are low. The HI-8202 provides a combination of two normally
closed and two normally open switches.
Industry-standard plastic package options include 20-pin
TSSOP, 16-pin DIP and 16-pin QFN. Ceramic packaging is
available on request. All three products are offered in both in-
dustrial (-40°C to +85°C) and extended (-55°C to +125°C) tem-
perature range options.
FEATURES
·CMOS analog switches with up to +/-12V switching range
from a single 3.3V or 5V supply
· Low RON: 10W max at 25°C
· Robust CMOS Silicon-on-Insulator (SOI) technology
· Switch nodes are open-circuit when chip is powered down
· SOI switch isolation with 1nA typical Off leakage
· ESD protection > 4KV HBM
· Fast switching time with break-before-make
· Low power
· Extended Temperature Range (-55°C to +125°C)
PIN CONFIGURATIONS (Top Views)
IN1 1
S1A 2
-3
S1B 4
V- 5
GND 6
S4B 7
-8
S4A 9
IN4 10
20 IN2
19 S2A
18 -
17 S2B
16 V+
15 VLOGIC
14 S3B
13 -
12 S3A
11 IN3
HI-8200PSx
20-Pin TSSOP package
APPLICATIONS
· Avionics
· Data bus isolation
· Sample-and-Hold circuits
· Test Equipment
· Communications Systems
(DS8200 Rev. B)
S1B 1
V- 2
GND 3
S4B 4
12 S2B
11 V+
10 VLOGIC
9 S3B
HI-8200PCx
16-pin 5mm x 5mm Chip-scale package
(see page 6 for additional package configurations)
PRODUCT OPTIONS
PART TYPE IN1 Switch 1 IN2 Switch 2 IN3 Switch 3 IN4 Switch 4
HI-8200 0 Open 0 Open 0 Open 0 Open
1 Closed 1 Closed 1 Closed 1 Closed
HI-8201 0 Closed 0 Closed 0 Closed 0 Closed
1 Open 1 Open 1 Open 1 Open
HI-8202 0 Open 0 Closed 0 Closed 0 Open
1 Closed 1 Open 1 Open 1 Closed
HOLT INTEGRATED CIRCUITS
www.holtic.com
12/12