BH67F2260 Datasheet, PDF (173/253 Pages) Holtek Semiconductor Inc – R-Sensor Blood Pressure Meter Flash MCU with LCD

BH67F2260/BH67F2270
R-Sensor Blood Pressure Meter Flash MCU with LCD
SPIA Bus Enable/Disable
To enable the SPIA bus, set SACSEN=1 and SCSA=0, then wait for data to be written into the
SPIAD (TXRX buffer) register. For the Master Mode, after data has been written to the SPIAD
(TXRX buffer) register, then transmission or reception will start automatically. When all the data has
been transferred the SATRF bit should be set. For the Slave Mode, when clock pulses are received
on SCKA, data in the TXRX buffer will be shifted out or data on SDIA will be shifted in.
When the SPIA bus is disabled, SCKA, SDIA, SDOA, SCSA can become I/O pins or other pin-
shared functions using the corresponding pin-shared control bits.
SPIA Operation Steps
All communication is carried out using the 4-line interface for either Master or Slave Mode.
The SACSEN bit in the SPIAC1 register controls the overall function of the SPIA interface. Setting
this bit high will enable the SPIA interface by allowing the SCSA line to be active, which can then
be used to control the SPIA interface. If the SACSEN bit is low, the SPIA interface will be disabled
and the SCSA line will be in a floating condition and can therefore not be used for control of the
SPIA interface. If the SACSEN bit and the SPIAEN bit in the SPIAC0 register are set high, this will
place the SDIA line in a floating condition and the SDOA line high. If in Master Mode the SCKA
line will be either high or low depending upon the clock polarity selection bit SACKPOLB in the
SPIAC1 register. If in Slave Mode the SCKA line will be in a floating condition. If SPIAEN is low
then the bus will be disabled and SCSA, SDIA, SDOA and SCKA will all become I/O pins or the
other functions using the corresponding pin-shared control bits. In the Master Mode the Master will
always generate the clock signal. The clock and data transmission will be initiated after data has
been written into the SPIAD register. In the Slave Mode, the clock signal will be received from an
external master device for both data transmission and reception. The following sequences show the
order to be followed for data transfer in both Master and Slave Mode.
Master Mode
• Step 1
Select the clock source and Master mode using the SASPI2~SASPI0 bits in the SPIAC0 control
register.
• Step 2
Setup the SACSEN bit and setup the SAMLS bit to choose if the data is MSB or LSB first, this
must be same as the Slave device.
• Step 3
Setup the SPIAEN bit in the SPIAC0 control register to enable the SPIA interface.
• Step 4
For write operations: write the data to the SPIAD register, which will actually place the data into
the TXRX buffer. Then use the SCKA and SCSA lines to output the data. After this go to step 5.
For read operations: the data transferred in on the SDIA line will be stored in the TXRX buffer
until all the data has been received at which point it will be latched into the SPIAD register.
• Step 5
Check the SAWCOL bit if set high then a collision error has occurred so return to step 4. If equal
to zero then go to the following step.
Rev. 1.00
173
March 15, 2017