HT1623_09 Datasheet, PDF (13/15 Pages) Holtek Semiconductor Inc – RAM Mapping 488 LCD Controller for I/O MCU

PATENTED
HT1623
Name
ID
Command Code
D/C
Function
Def.
TONE 2K
1 0 0 0110-XXXX-X
C Tone frequency output: 2kHz
IRQ DIS
1 0 0 100X-0XXX-X
C Disable IRQ output
Yes
IRQ EN
1 0 0 100X-1XXX-X
C Enable IRQ output
F1
1 0 0 101X-0000-X
C
Time base clock output: 1Hz
The WDT time-out flag after: 4s
F2
1 0 0 101X-0001-X
C
Time base clock output: 2Hz
The WDT time-out flag after: 2s
F4
1 0 0 101X-0010-X
C
Time base clock output: 4Hz
The WDT time-out flag after: 1s
F8
1 0 0 101X-0011-X
C
Time base clock output: 8Hz
The WDT time-out flag after: 1/2s
F16
1 0 0 101X-0100-X
C
Time base clock output: 16Hz
The WDT time-out flag after: 1/4s
F32
1 0 0 101X-0101-X
C
Time base clock output: 32Hz
The WDT time-out flag after: 1/8s
F64
1 0 0 101X-0110-X
C
Time base clock output: 64Hz
The WDT time-out flag after: 1/16s
F128
1 0 0 101X-0111-X
C
Time base clock output: 128Hz
The WDT time-out flag after: 1/32s
Yes
TEST
1 0 0 1110-0000-X
C Test mode, user don¢t use.
NORMAL
1 0 0 1110-0011-X
C Normal mode
Yes
Note:
X : Don¢t care
A6~A0 : RAM address
D3~D0 : RAM data
D/C : Data/Command mode
Def. : Power on reset default
All the bold forms, namely 1 1 0, 1 0 1, and 1 0 0, are mode commands. Of these, 1 0 0 indicates the command
mode ID. If successive commands have been issued, the command mode ID except for the first command will
be omitted. The source of the tone frequency and of the time base or WDT clock frequency can be derived from
an on-chip 32kHz RC oscillator, a 32.768kHz crystal oscillator, or an external 32kHz clock. Calculation of the
frequency is based on the system frequency sources as stated above. It is recommended that the host control-
ler should initialize the HT1623 after power on reset, for power on reset may fail, which in turn leads to the mal-
functioning of the HT1623.
Rev. 1.50
13
June 17, 2009