HMC871LC5_10 Datasheet, PDF (7/10 Pages) Hittite Microwave Corporation – EA OPTICAL MODULATOR DRIVER, DC - 20 GHz

v02.0110
Outline Drawing
HMC871LC5
EA OPTICAL MODULATOR
DRIVER, DC - 20 GHz
10
NOTES:
1. PACKAGE BODY MATERIAL: ALUMINA
2. LEAD AND GROUND PADDLE PLATING: 30-80 MICROINCHES
GOLD OVER 50 MICROINCHES MINIMUM NICKEL.
3. DIMENSIONS ARE IN INCHES [MILLIMETERS].
4. LEAD SPACING TOLERANCE IS NON-CUMULATIVE.
5. PACKAGE WARP SHALL NOT EXCEED 0.05mm DATUM -C-
6. ALL GROUND LEADS AND GROUND PADDLE MUST BE
SOLDERED TO PCB RF GROUND.
Pin Descriptions
Pin Number
Function
1, 3, 4, 7 - 12, 14,
N/C
16 - 20, 23 - 29, 31
Description
The pins are not connected internally; however, all data
shown herein was measured with these pins connected
to RF/DC ground externally.
Interface Schematic
2
VC
Output voltage swing adjust. +0.5V should
be applied for nominal operation.
10 - 20
5
6, 21
13
RFIN
GND
ACG2
This pin is DC coupled
and matched to 50 Ohms.
DC blocking is required.
These pins and exposed package base
must be connected to RF/DC ground.
Low frequency termination. Attach bypass
capacitor per application circuit herein.
For price, delivery, and to place orders, please contact Hittite Microwave Corporation:
20 Alpha Road, Chelmsford, MA 01824 Phone: [phone] Fax: [phone]
Order On-line at www.hittite.com