HMC625HFLP5E Datasheet, PDF (6/8 Pages) Hittite Microwave Corporation – 0.5 dB LSB GaAs MMIC 6-BIT DIGITAL VARIABLE GAIN AMPLIFIER, 0.5 - 6 GHz

Outline Drawing
v00.0311
HMC625HFLP5E
0.5 dB LSB GaAs MMIC 6-BIT DIGITAL
VARIABLE GAIN AMPLIFIER, 0.5 - 6 GHz
Package Information
NOTES:
1. LEADFRAME MATERIAL: COPPER ALLOY
2. DIMENSIONS ARE IN INCHES [MILLIMETERS]
3. LEAD SPACING TOLERANCE IS NON-CUMULATIVE.
4. PAD BURR LENGTH SHALL BE 0.15 mm MAXIMUM.
PAD BURR HEIGHT SHALL BE 0.05 mm MAXIMUM.
5. PACKAGE WARP SHALL NOT EXCEED 0.05 mm.
6. ALL GROUND LEADS AND GROUND PADDLE MUST BE
SOLDERED TO PCB RF GROUND.
7. REFER TO HITTITE APPLICATION NOTE FOR SUGGESTED LAND PATTERN.
Part Number
Package Body Material
Lead Finish
HMC625HFLP5E RoHS-compliant Low Stress Injection Molded Plastic 100% matte Sn
[1] Max peak reflow temperature of 260 °C
[2] 4-Digit lot number XXXX
MSL Rating
MSL1 ^[1]
Package Marking ^[2]
H625HF
XXXX
Pin Descriptions
Pin Number
Function
1
AMPIN
29
AMPOUT
2, 3, 13,
28, 30 - 32
4, 12
GND
ATTIN,
ATTOUT
Description
This pin is DC coupled.
An off chip DC blocking capacitor is required.
RF output and DC bias (Vcc) for
the output stage of the amplifier.
These pins and package bottom
must be connected to RF/DC ground.
These pins are DC coupled and matched to 50 Ohms.
Blocking capacitors are required. Select value based
on lowest frequency of operation.
Interface Schematic
For price, delivery and to place orders: Hittite Microwave Corporation, 20 Alpha Road, Chelmsford, MA 01824
Phone: [phone] Fax: [phone] Order On-line at www.hittite.com
Application Support: Phone: [phone] or [e-mail]
0-6