HMC487LP5_09 Datasheet, PDF (6/6 Pages) Hittite Microwave Corporation – SURFACE MOUNT PHEMT 2 WATT POWER AMPLIFIER, 9 - 12 GHz

Evaluation PCB
HMC487LP5 / 487LP5E
v01.0705
SURFACE MOUNT PHEMT 2 WATT POWER
AMPLIFIER, 9 - 12 GHz
11
List of Materials for Evaluation PCB 108190 ^[1]
Item
Description
J1, J2
SRI PC Mount SMA Connector
J3, J4
2mm DC Header
C1 - C6
100 pF capacitor, 0402 pkg.
C7 - C12
2.2μF Capacitor, Tantalum
U1
PCB ^[2]
HMC487LP5 / HMC487LP5E Amplifier
108188 Evaluation PCB
[1] Reference this number when ordering complete evaluation PCB
[2] Circuit Board Material: Rogers 4350.
The circuit board used in this application should use
RF circuit design techniques. Signal lines should
have 50 ohm impedance while the package ground
leads and exposed paddle should be connected
directly to the ground plane similar to that shown.
A sufficient number of via holes should be used to
connect the top and bottom ground planes. Copper
filled vias under the device are recommended. The
evaluation board should be mounted to an appro-
priate heat sink. The evaluation circuit board shown
is available from Hittite upon request.
For price, delivery, and to place orders, please contact Hittite Microwave Corporation:
20 Alpha Road, Chelmsford, MA 01824 Phone: [phone] Fax: [phone]
Order On-line at www.hittite.com
11 - 275