HMC530LP5_11 Datasheet, PDF (4/6 Pages) Hittite Microwave Corporation – MMIC VCO w/ HALF FREQUENCY OUTPUT & DIVIDE-BY-4, 9.5 - 10.8 GHz

Outline Drawing
HMC530LP5 / 530LP5E
v07.0411
MMIC VCO w/ HALF FREQUENCY OUTPUT
& DIVIDE-BY-4, 9.5 - 10.8 GHz
Package Information
NOTES:
1. LEADFRAME MATERIAL: COPPER ALLOY
2. DIMENSIONS ARE IN INCHES [MILLIMETERS]
3. LEAD SPACING TOLERANCE IS NON-CUMULATIVE.
4. PAD BURR LENGTH SHALL BE 0.15 mm MAXIMUM.
PAD BURR HEIGHT SHALL BE 0.05 mm MAXIMUM.
5. PACKAGE WARP SHALL NOT EXCEED 0.05 mm.
6. ALL GROUND LEADS AND GROUND PADDLE MUST BE
SOLDERED TO PCB RF GROUND.
7. REFER TO HITTITE APPLICATION NOTE FOR SUGGESTED LAND PATTERN.
Part Number
HMC530LP5
Package Body Material
Low Stress Injection Molded Plastic
Lead Finish
Sn/Pb Solder
HMC530LP5E RoHS-compliant Low Stress Injection Molded Plastic
[1] Max peak reflow temperature of 235 °C
[2] Max peak reflow temperature of 260 °C
[3] 4-Digit lot number XXXX
100% matte Sn
MSL Rating
MSL3 ^[1]
MSL3 ^[2]
Package Marking ^[3]
H530
XXXX
H530
XXXX
Pin Descriptions
Pin Number
Function
1 - 3, 8 - 10, 13 - 18,
20, 22 - 28, 30 - 32
N/C
Description
No Connection. These pins may be connected to RF/
DC ground. Performance will not be affected.
Interface Schematic
4
RFOUT/4
Divide-by-4 output. DC block required.
8
Supply voltage for prescaler. If prescaler is not
6
Vcc (Dig)
required, this pin may be left open to conserve
approximately 65 mA of current.
For price, delivery and to place orders: Hittite Microwave Corporation, 2 Elizabeth Drive, Chelmsford, MA 01824
Phone: [phone] Fax: [phone] Order On-line at www.hittite.com
Application Support: Phone: [phone] or [e-mail]
8-4