HMC1023LP5E Datasheet, PDF (20/30 Pages) Hittite Microwave Corporation – Anti-aliasing and reconstruction filters

v01.0113
HMC1023LP5E
72 MHz DUAL PROGRAMMABLE
LOW PASS FILTER WITH DRIVER
HMC1023LP5E Ordering Information
The HMC1023LP5E is available as product that is either un-programmed or pre-programmed. Programming is
available to a variety of filter bandwidths (defined in this context as the 3dB bandwidth).
Other options available for pre-programmed product include the single path gain and bias state as described below.
Gain and bias settings are described in Reg 02h.
When placing an order for the HMC1023LP5E please observe the following guidelines.
1. To order the un-programmed standard part please place order using the part number HMC1023LP5E-000000.
2. To order a pre-programmed HMC1023LP5E please determine the part number as described below and then
contact Hittite Sales at [e-mail] or call [phone].
2.1 Minimum quantity order for the pre-programmed HMC1023LP5E-BBBGLL is 500 pieces.
3. Pre-Programmed part number description: HMC1023LP5E-BBBGL.
3.1 ‘BBB’ represents a three digit number from the Table 10 that represents the desired bandwidth setting
(3 dB bandwidth) from 5 MHz to 72 MHz (for example BBB = 050 specifies a 5 MHz corner frequency).
3.2 ‘G’ represents the gain setting of either 0 dB (G = 0) or 10 dB (G = 1).
3.3 ‘LL’ represents the OpAmp bias setting of the HMC1023LP5E. For more information please see “Linearity,
Bandwidth Accuracy, and Current Consumption” section.
For example, to order the HMC1023LP5E pre-programmed for 72 MHz 3 dB frequency, 10 dB gain, and standard low
‘00’ OpAmp bias setting please specify part number HMC1023LP5E-720100.
Table 10. Custom Part Frequency Options
BBB frequency for custom part (actual frequency is BBB x 0.1 MHz)
050
069
093
128
171
229
307
411
554
709
052
070
095
131
175
235
315
422
565
720
053
071
098
134
179
240
322
432
576
054
073
100
137
180
246
330
443
587
056
075
102
140
184
253
338
454
598
057
076
105
141
188
259
347
465
609
058
078
108
144
193
265
355
476
621
060
080
110
148
198
272
364
488
632
061
082
113
151
203
278
373
500
643
063
084
116
155
208
280
382
510
654
064
086
119
159
213
285
392
521
665
066
088
121
163
218
292
400
532
676
068
091
124
167
224
300
401
543
687
For additional information or inquiries please contact Hittite Apps Support at [e-mail].
[1] The Output IP2 and Output IP3 for the two linearity settings are shown in Figure 13 and Figure 14. High linearity setting improves linearity for
bandwidths greater than 30 MHz at the cost of increased current consumption (additional 25 mA).
For price, delivery and to place orders: Hittite Microwave Corporation, 2 Elizabeth Drive, Chelmsford, MA 01824
Phone: [phone] Fax: [phone] Order On-line at www.hittite.com
20
Application Support: Phone: [phone] or [e-mail]