HMC713LP3E_10 Datasheet, PDF (10/12 Pages) Hittite Microwave Corporation – 54 dB, LOGARITHMIC DETECTOR / CONTROLLER, 50 - 8000 MHz

HMC713LP3E
v01.1009
54 dB, LOGARITHMIC
DETECTOR / CONTROLLER, 50 - 8000 MHz
Application & Evaluation PCB Schematic
11
Notes
Note 1: The HMC713LP3E evaluation board is pre-assembled for single-ended input, and detector/RSSI mode.
Note 2: For detector mode, connect high impedance volt meter to the OUTP / OUTN port.
Note 3: For controller mode, remove R9 & C3 and install 1k Ω resistor (R7, not included) and 100pF capacitor (C2, not included),
then make appropriate connection to OUTP and VSET. In controller mode, the OUTP / OUTN output can be used to drive
a variable gain amplifier, or a variable attenuator, either directly or through a buffer or microcontroller. VSET should be
connected to an external supply, typically between +0.2 and +1.2V.
Note 4: An external capacitance C1 can be connected to CLPF port for additional filtering of OUTP and OUTN outputs..
For price, delivery and to place orders: Hittite Microwave Corporation, 20 Alpha Road, Chelmsford, MA 01824
Phone: [phone] Fax: [phone] Order On-line at www.hittite.com
Application Support: Phone: [phone] or [e-mail]
11 - 10