HVI43 Datasheet, PDF (1/2 Pages) HITRON ELECTRONICS CORPORTION – UNIVERSAL INPUT AC-DC OPEN FRAME SINGLE & TRIPLE OUTPUT 43 WATTS INTERNAL SWITCHING POWER SUPPLIES

H HiTRON
UNIVERSAL INPUT AC-DC OPEN FRAME SINGLE &
TRIPLE OUTPUT 43 WATTS INTERNAL SWITCHING
POWER SUPPLIES HVI43 SERIES
FEATURES:
ACCOMMODATE UNIVERSAL AC SOURCES
COMPACT 4”x2”x1” PCB FORMAT
MEET UNIVERSAL SAFETY STANDARDS
EMI MEET CISPR PUB. 22 & FCC CLASS B
CE MARKING COMPLIANCE
SPECIFICATION
INPUT SPECIFICATION
Input Voltage: Range typ. 90-264Vac.
Rating 100 to 240Vac.
Input Connector: V-M connector.
Input Frequency: 47-63Hz.
Inrush Current: ≤12A rms cold start @230Vac.
Input Current: Typ. 0.7A@115Vac, 0.35A@230Vac.
Dielectric Withstand: Meet IEC 60950-1.
EMI: Meet CISPR PUB. 22 & FCC Class B.
Hold-up Time: Typ. 20mS @115Vac, 100mS @ 230Vac.
Earth Leakage: Less than 0.4mA @230Vac.
OUTPUT SPECIFICATION
Output Voltage: See Ratings Chart.
Output Current: See Ratings Chart.
Output Connector: V-M connector.
Output Wattage: Typ. 42 watts.
Line Regulation: Typ. 0.2%.
Load Regulation: Main VO1 typ. ±2-3%.
Aux.VO2 typ. ± 4-6%(Common choke).
Aux.VO3 typ. ± 3.0%(P.R.).
Noise & Ripple: Typ. 1.0% peak to peak.
OVP: Built-in at main output VO1(Latch).
Adjustability: Not available.
Overload Protection (OLP): Fully protected against
outputs overload and short circuit.
Typ. OLP set at 105-120% of rating output power.
Consult the factory for OLP setting
GENERAL SPECIFICATION
Efficiency: Typ. 75-80%(Various with output voltage).
Switching Frequency: 130 KHz or 70KHz.
Circuit Topology: Fixed frequency forward circuit for triple
output and 5V/3.3V of single output.
Fixed frequency flyback circuit for high
Operating Temperature: 0 to +50 °C under forced air flow
for full load. .Derate by 1.3W/ °C
from 40°C to 50 °C.
Storage Temperature: -20 to +85°C.
voltage of single output.
Temperature Coefficient: Typ. 0.04%/°C.
Transient Response: Output voltage returns in less than
0.5mS following a 50% load change.
Safety Standard: IEC 60950-1 Class I.
Power Density: 5.5Watts / Cubic Inch.
Cooling: At least 5 cfm(100LFM) direct forward air flow is
required to achieve full rating power.
Construction: 4”x2”x1” PCB format.
Note: Due to requests in market and advances in technology, specifications subject to change without notification.
-13-
In application