English
Language : 

HEMG75 Datasheet, PDF (1/2 Pages) HITRON ELECTRONICS CORPORTION – AC/DC MEDICAL APPLICATION EXTERNAL ADAPTER UNIVERSAL INPUT SINGLE OUTPUT 70 WATTS GREEN POWER SWITCHING POWER SUPPLIES
H HiTRON
2007/10/5
AC/DC MEDICAL APPLICATION EXTERNAL ADAPTER
UNIVERSAL INPUT SINGLE OUTPUT 70 WATTS GREEN POWER
SWITCHING POWER SUPPLIES HEMG75 SERIES
FEATURES:
„ ACCOMMODATE UNIVERSAL AC SOURCES
„ DESKTOP IEC320-3P AC RECEPTACLE
„ MEET MEDICAL STANDARDS EN60601-/
UL60601-1
„ GREEN POWER DESIGN/ MEET ENERGY
STAR(CEC) LVEVL IV
„ EMI MEET EN 55011/ FCC CLASS B
„ CE MARKING COMPLIANCE
SPECIFICATION
INPUT SPECIFICATION
Input Voltage: Typ. 90-264Vac.
Input Connector: IEC320-3P DT7 AC input receptacle.
Input Frequency: 47-63Hz.
Inrush Current: Typ. 57.6A @ 230Vac.
Input Current: Typ. 1.2A @ 115Vac, 0.59A @ 230Vac.
Dielectric Withstand: Meet IEC60601-1.
EMI: Meet EN55011 / FCC Class B.
Hold-up Time: Typ. 15.7mS @ 115Vac, 82.6mS @ 230Vac.
Over Temp. Protection: Available.
Green Power: >0.5W @ 230Vac.
Earth Leakage: Less than 100uA.
OUTPUT SPECIFICATION
Output Voltage: See Ratings Chart.
Output Current: See Ratings Chart.
Output Wattage: Typ. 70 W.
Output Connector & Cord: Optional.
Line Regulation: Typ. 1%.
Load Regulation: Typ. ±3%.
Noise & Ripple: Typ. 1% peak to peak.
OVP: Built-in by latch circuit.
Adjustability: Factory set.
Over Current Protection (OCP):
Fully protected against output overload and short circuit.
OLP set at about 125-150% rating output wattage.
Consult the factory for OLP setting.
GENERAL SPECIFICATION
Efficiency: Typ. 84-85%.
Operating Temperature: 0 to +25/35/40°C
Switching Frequency: Typ. 60KHz.
without derating. (various with output voltage)
Circuit Topology: Fixed Frequency flyback circuit.
Storage Temperature: -20 to +85 °C.
Transient Response: Output voltage returns in less than Temperature Coefficient: 0.04 °C
1mS following a 25% load change.. Cooling: Free air convection.
Safety Standard: Medical standards IEC60601-1/
Construction: Impact resistant thermo-plastic
EN60601-1/ UL60601-1, Class I for DT7.
enclosure case.
Power Density: 4.38Watts. / Cubic Inch.
Desktop Format.
NOTE: (1) All measurements are at nominal input, full load, and +25°C unless otherwise specified.
(2) Load regulation is measured at 115Vac or 230Vac in percentage to indicate the change in output voltage as the load varied from half load to full load (±%).
(3) The exact obtainable load regulation depends upon the output cord selected and load current. Upper data are for 6 ft. (2 m)cord AWG#18 wires.
(4) Due to requests in market and advances in technology, specifications subject to change without notice.
For the details of safety approval, please consult the factory.