HAC203P Datasheet, PDF (1/2 Pages) HITRON ELECTRONICS CORPORTION – UNIVERSAL AC INPUT HARMONIC CORRECTION AC-DC HOT-SWAP LOW VOLTAGE CompactPCI PENTA OUTPUT 200 WATTS ACTIVE CURRENT SHARING SWITCHING POWER SUPPLIES

H HiTRON
UNIVERSAL AC INPUT HARMONIC CORRECTION
AC-DC HOT-SWAP LOW VOLTAGE CompactPCI
PENTA OUTPUT 200 WATTS ACTIVE CURRENT SHARING
SWITCHING POWER SUPPLIES HAC203P SERIES
FEATURES:
200W 3U X 9HP EUROCARD PACKAGE
MEET IEC 61000-3-2 HARMONIC
CORRECTION
INTERNAL OR-ING DIODES FOR
N+1 REDUNDANCY
HOT-SWAPPABLE
THIRD-WIRE CURRENT SHARING
EMI MEET EN 55022 / FCC CLASS A
CE MARKING COMPLIANCE
FULLY COMPLIANT WITH PICMG
SPECIFICATION
INPUT SPECIFICATION
Input Voltage: Typ. 90-264Vac.
Power Factor Correction: Meet Harmonic Correction
IEC 61000-3-2.Power Factor typ. 0.97-0.98.
Input Connector: Positronic 47-pin PCIH47M400A1.
Input Frequency: 47-63Hz.
Inrush Current: 8.66Arms @ 230Vac.
Input Current: 2.5A @115Vac/1.18A @230Vac.
Dielectric Withstand: Meet IEC 60950-1 regulation.
EMI: Meet EN 55022 / FCC Class A.
Hold-up Time: 18.4mS @115Vac, 20.8mS @230Vac.
Earth Leakage: Less than 0.64mA @230Vac.
Remote ON/OFF: Available at [INH#] & [EN#] pins.
Status LED: <Green> means valid input voltage.
<Amber> means a critical fault.
Thermal Protection (OTP): Installed NTC and thermostat for
thermal sensor at [DEG#] pin.
OUTPUT SPECIFICATION
Output Voltage: See Ratings Chart.
Output Current: See Ratings Chart.
Output Wattage: Typ. 200W continuous.
Output Connector: Positronic 47-pin PCIH47M400A1.
Line Regulation: Typ. 0.2%.
Load Regulation: Typ. ±1%.
Noise & Ripple: Typ. 1% peak to peak or 55mV,
whichever is greater.
OVP: Built-in at all outputs.
Adjustability: Available at VO1,2,3 & 4.
Remote Sensing: Available at VO1,VO2,VO3 & VO4.
Hot-Swap: Available.
N+1 Redundancy: Installed with internal OR-ing diodes
at all outputs for N+1 redundancy operation.
Current Sharing: Third-wire current sharing at VO1,2,3 & 4.
Over Current Protection (OCP): Installed at each rail.
DC OK: Available at VO1,2,3,4 & 5.
Overload Protection (OLP): Fully protected against output
overload or short circuit. Typical 120-150% max. load.
Consult the factory for special OLP setting.
GENERAL SPECIFICATION
Efficiency: Typ. 67-69 %.
Switching Frequency: 133K Hz.
Circuit Topology: Forward circuit.
Transient Response: Peak transient less than 50mV and
recovers within 0.96mS after 25% load-change.
Safety Standard: IEC 60950-1 Class I.
Construction: Eurocard 3U X 9HP X 185mm
CompactPCI format.
Operating Temperature: -5 to +50 °C at full load with
specified air flow. Derates linearly to 50% at +60 °C.
Storage Temperature: -40 to +85 °C.
Temperature Coefficient: Typ. ±0.02% / °C.
Cooling: At least 14CFM moving air is required to achieve
full rating power 200W in a confined area.
Power Density: 2.85 Watts/ Cubic Inch.
Note: Due to requests in market and advances in technology, specifications subject to change without notification.
In application
-3-