HAC202P Datasheet, PDF (1/2 Pages) HITRON ELECTRONICS CORPORTION – UNIVERSAL AC INPUT HARMONIC CORRECTION AC-DC HALF SIZE HOT-SWAP CompactPCI QUAD OUTPUT 200 WATTS ACTIVE CURRENT SHARING SWITCHING POWER SUPPLIES

H HiTRON
2008/10/15
UNIVERSAL AC INPUT HARMONIC CORRECTION AC-DC HALF SIZE
HOT-SWAP CompactPCI QUAD OUTPUT 200 WATTS ACTIVE CURRENT
SHARING SWITCHING POWER SUPPLIES HAC202P SERIES
FEATURES:
„ 200W 3U X 4HP HALF SIZE
EUROCARD PACKAGE
„ MEET IEC 61000-3-2 HARMONIC
CORRECTION
„ INTERNAL OR-ING DIODES FOR
N+1 REDUNDANCY
„ HOT-SWAPPABLE
„ THIRD-WIRE CURRENT SHARING
„ EMI MEET EN 55022 / FCC CLASS A
„ CE MARKING COMPLIANCE
„ FULLY COMPLIANT WITH PICMG
SPECIFICATION
INPUT SPECIFICATION
Input Voltage: Typ. 90-264Vac.
Power Factor Correction: Meet Harmonic Correction
IEC 61000-3-2.Power Factor typ. 0.98-0.99.
Input Connector: Positronic 47-pin PCIH47M400A1.
Input Frequency: 47-63Hz.
Inrush Current: 6.85Arms @ 230Vac 50Hz.
Input Current: 2.45A @115Vac/1.13A @230Vac.
Dielectric Withstand: Meet IEC 60950-1 regulation.
EMI: Meet EN 55022 / FCC Class A.
Hold-up Time: 16.8mS @115Vac/230Vac.
Leakage Current: 0.45mA for IEC60950-1 Touch current.
Remote ON/OFF: Available at [INH#] & [EN#] pins.
Power Fail Signal: Available at [FAL#] pin.
Status LED: <Green> means valid input voltage.
<Amber> means a critical fault.
Thermal Protection (OTP): Installed NTC and
thermostat for thermal sensor at [DEG#] pin.
OUTPUT SPECIFICATION
Output Voltage: See Ratings Chart.
Output Current: See Ratings Chart.
Output Wattage: Typ. 200W continuous.
Output Connector: Positronic 47-pin PCIH47M400A1.
Line Regulation: Typ. 0.1%.
Load Regulation: Typ. ±1%.
Total Regulation: Typ. ±1.5%.
Noise & Ripple: Typ. 1% peak to peak .
OVP: Built-in at all outputs.
Adjustability: Available at VO1,2&3.
Remote Sensing: Available at VO1,VO2 & VO3.
Hot-Swap: Available.
N+1 Redundancy: Installed with internal OR-ing diodes
at all outputs for N+1 redundancy operation.
Current Sharing: Third-wire current sharing at VO1,2 &3.
Power OK Signal: Available for all output.
Over Current Protection (OCP): Installed at each rail.
Overload Protection (OLP): Fully protected against output
overload or short circuit. Typical 115-135% max. load.
Consult the factory for special OLP setting.
GENERAL SPECIFICATION
Efficiency: Typ. 75.5-80 %.
Switching Frequency: 125K Hz.
Circuit Topology: Forward circuit.
Transient Response: Peak transient less than 105mV and
recovers within 0.084mS after 25% load-change.
Safety Standard: IEC 60950-1 Class I.
Construction: Eurocard 3U X 4HP X 160mm
CompactPCI format.
Operating Temperature: 0 to +50 °C at full load with
specified air flow. Derates linearly to 50% at +70 °C.
Storage Temperature: -40 to +85 °C.
Temperature Coefficient: Typ. ±0.02% / °C.
Cooling: At least 30CFM(800 LFM) moving air is required
to achieve full rating power 200W in a confined area.
Power Density: 7.4 Watts/ Cubic Inch.
Note: Due to requests in market and advances in technology, specifications subject to change without notification.
1