HIF3BA-10D-2.54C Datasheet, PDF (20/30 Pages) Hirose Electric – Ribbon Cable connector Compliant with MIL Standard

HIF3B SeriesqRibbon Cable connector Compliant with MIL Standard
BSocket Side (Crimping) Assembling Procedures
(1) As shown in Figure 1, peel the applicable cable (AWG#20 to #26) jacket, and connect it using crimping jig HIF3-TA2022HC,
HIF3-TA2226HC, or HIF3-TA2426HC. In this case, insert the cable so as to hit the contact cable stripper position as shown
Figure 2.
(2) After connection as shown Figure 2, check the contact direction, and insert the contact as shown Figures 3 and 4. Slightly pull
the cable, and check whether the contact lance position is firmly fixed to the insulation case, as shown in the area (A).
Note1 : For handling procedures for special crimping tools, refer to the "Handling Instruction Manual".
Note2 : Wire strip length: Refer to crimp condition sheet.
Wire strip length
Figure 1
Figure 2
Figure 3
B34
Figure 4