U.FL-R-SMT Datasheet, PDF (2/8 Pages) Hirose Electric – Ultra Small SMT Coaxial Connectors - Low Profile 1.9mm or 2.4mm Mated Height

s Product Specifications
Ratings
Nominal characteristic impedance
Voltage rating
Frequency range
50 ohms
60 V AC (rms)
DC to 6 GHz
Operating temperature range
Operating humidity
-40˚C to +90˚C
90% max.
Item
Specification
Conditions
1. Contact resistance
Center: 20 m ohms max.
Outside: 10 m ohms max.
10 mA max.
2. Insulation resistance
500 M ohms min.
100 V DC
3. Withstanding voltage
No flashover or insulation breakdown.
200 V AC / 1 minute
4. V.S.W.R.*
Part No.
Up to 3GHz
3 to 6GHz
U.FL-LP-040 dia.0.81mm Coaxial Cable Assembly
1.3 Max
1.35 Max
U.FL-LP(V)-040 dia.0.81mm Coaxial Cable Assembly
1.3 Max
1.3 Max
U.FL-LP-066 dia.1.13mm Coaxial Cable Assembly
1.3 Max
1.4 Max
U.FL-LP-066 dia.1.32mm Coaxial Cable Assembly
1.3 Max
1.5 Max
U.FL-LP-062 dia.1mm Coaxial Cable Assembly
1.3 Max
1.3 Max
U.FL-LP-088 dia.1.37mm Coaxial Cable Assembly
1.3 Max
1.4 Max
5. Female contact holding force 0.15 N min.
Measured with a Ø 0.475 pin gauge
6. Durability
Contact resistance
(mating/un-mating,
Center: 25 m ohms max.
30 cycles
with corresponding plug)
Outside: 15 m ohms max.
7. Vibration
Frequency: 10 to 100 Hz, single amplitude of 1.5mm, acceleration
No electrical discontinuity of 1µs min.
of 59m/s², for 5 cycles in the direction of each of the 3 axis.
8. Shock
No damage, cracks or parts dislocation.
Acceleration of 735 m/s², 11ms duration, sine half-wave
waveform, 2 cycles in each of 3 axes.
9. Humidity
No damage, cracks or parts dislocation.
(Steady state)
Insulation resistance 100 M ohms min.(when humidity high) 96 hours at temperature of 40ç and humidity of 95%.
Insulation resistance 500 M ohms min.(when dry)
10. Temperature cycle
No damage, cracks or parts dislocation.
Temperature:-40˚C/+5 to +35˚C/+90˚C/+5 to +35˚C
Contact resistance:25 m ohms max. (Center)
Time:
30 / 5 max. /30 /5 max.(Minutes)
15 m ohms max. (Outside)
5 cycles
11. Salt spray test
No excessive corrosion
5% salt water solution, 48 hours
*V.S.W.R. Measurement System
The above V.S.W.R. standard values were measured using the measurement system of the diagram below.
sMaterials
Part
Shell
Male center contact
Female center contact
Insulator
Note 1: Cable type connectors were measured with SMA conversion adapters
attached to both ends of the harness product of a suitable 100cm cable.
Note 2: Board type connectors were mounted to a 50Ω glass epoxy board and
measurements were conducted with SMA conversion adapters attached.
Material
Phosphor bronze
Brass
Phosphor bronze
Plug
PBT
Receptacle
LCP
Finish
Silver plating
Gold plating
Gold plating
Color: Black
Color: Beige
Remarks
—————
—————
—————
UL94V-0
UL94V-0
2