|
U.FL-LP Datasheet, PDF (2/7 Pages) Hirose Electric – Ultra Small Surface Mount Coaxial Connectors - Low Profile 1.9mm or 2.4mm Mated Height | |||
|
◁ |
The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.
All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your Hirose sales representative.
s Product Specifications
Ratings
Nominal characteristic impedance
Voltage rating
Frequency range
50 ohms
60 V AC (rms)
DC to 6 GHz
Operating temperature range
Operating humidity
-40ËC to +90ËC
90% max.
Item
Specification
Conditions
1. Contact resistance
Center: 20 m ohms max.
Outside: 10 m ohms max.
10 mA max.
2. Insulation resistance
500 M ohms min.
100 V DC
3. Withstanding voltage
No flashover or insulation breakdown.
200 V AC / 1 minute
4. V.S.W.R.*
Part No.
Up to 3GHz
3 to 6GHz
U.FL-LP-040 dia.0.81mm Coaxial Cable Assembly
1.3 Max
1.35 Max
U.FL-LP(V)-040 dia.0.81mm Coaxial Cable Assembly
1.3 Max
1.3 Max
U.FL-LP-068 dia.1.13mm Coaxial Cable Assembly
1.3 Max
1.4 Max
U.FL-LP-066 dia.1.32mm Coaxial Cable Assembly
1.3 Max
1.5 Max
U.FL-LP-062 dia.1mm Coaxial Cable Assembly
1.3 Max
1.3 Max
U.FL-LP-088 dia.1.37mm Coaxial Cable Assembly
1.3 Max
1.4 Max
5. Center contact holding force 0.15 N min.
Measured with a à 0.475 pin gauge
6. Durability
Contact resistance
(mating/un-mating,
Center: 25 m ohms max.
30 cycles
with corresponding plug)
Outside: 15 m ohms max.
7. Vibration
Frequency: 10 to 100 Hz, single amplitude of 1.5mm, acceleration
No electrical discontinuity of 1µs min.
of 59m/s2, for 5 cycles in the direction of each of the 3 axis.
8. Shock
No damage, cracks or parts dislocation.
Acceleration of 735 m/s2, 11ms duration, sine half-wave
waveform, 6 cycles in each of 3 axes.
9. Humidity
No damage, cracks or parts dislocation.
(Steady state)
Insulation resistance 100 M ohms min.(when humidity high) 96 hours at temperature of 40ç and humidity of 95%.
Insulation resistance 500 M ohms min.(when dry)
10. Temperature cycle
No damage, cracks or parts dislocation.
Temperature:-40ËC/+5 to +35ËC/+90ËC/+5 to +35ËC
Contact resistance:25 m ohms max. (Center)
Time:
30 / 5 max. /30 /5 max.(Minutes)
15 m ohms max. (Outside)
5 cycles
11. Salt spray test
No excessive corrosion
5% salt water solution, 48 hours
*V.S.W.R. Measurement System
The above V.S.W.R. standard values were measured using the measurement connection shown below.
Note 1: Cable type connectors were measured with SMA conversion adapters
attached to both ends of the harness product of a suitable 100cm cable.
Note 2: Board type connectors were mounted to a 50⦠glass epoxy board and
measurements were conducted with SMA conversion adapters attached.
sMaterial/Finishes
Part
Shell
Male center contact
Female center contact
Insulator
Material
Phosphor bronze
Brass
Phosphor bronze
Plug
PBT
Receptacle
LCP
Finish
Silver plated
Gold plated
Gold plated
Color: Black
Color: Beige
Remarks
âââââ
âââââ
âââââ
UL94V-0
UL94V-0
2
|
▷ |