|
N.FL Datasheet, PDF (2/6 Pages) Hirose Electric – Lightweight SMT Miniature Coaxial Connectors – 1.4 mm Mated Height | |||
|
◁ |
N.FL SeriesâLightweight SMT Miniature Coaxial Connectors â 1.4 mm Mated Height
â Specifications
Ratings
Nominal characteristic impedance
50 ohms
Operating temperature range
Frequency range
DC to 6 GHz Storage temperature range
-40°C to +90°C
(90% RH max.)
-30°C to +70°C
(90% RH max.)
Item
1. Contact resistance
2. Insulation resistance
3. Withstanding voltage
4. V.S.W.R.(Note)
Specification
Center contact: 25 m ohms max.
Outer contact: 25 m ohms max.
500 M ohms min.
No flashover or insulation breakdown
1.3max.
Conditions
10 mA max.
100V DC
200V AC / 1 minute
DC to 6GHz
5. Durability
Contact resistance Center contact: 30 m ohms max.
Outer contact: 30 m ohms max.
No damage, cracks, or parts dislocation
20 cycles
6. Vibration
No electrical discontinuity of 1 µs or longer
No damage, cracks, or parts dislocation
Frequency: 10 to 100 Hz, single amplitude of 1.5 mm
Acceleration: 59 m/s2, in each of 3 axis
5 cycles
7. Shock
No electrical discontinuity of 1 µs or longer
No damage, cracks, or parts dislocation
Acceleration of 735 m/s2, 11 ms continuous time
Waveform: sine half-wave, 3 cycles in each of the 3 axis
Insulation resistance: 100 M ohms min. (high humidity)
8. Humidity
Insulation resistance: 500 M ohms min. (dry)
96 hours at +40°C, and humidity of 95%
No damage, cracks, or parts dislocation
9. Temperature cycle
No damage, cracks, or parts dislocation
Temperature:-40°C/+5°C to +35°C/+90°C/+5°C to +35°C
Time: 30 min./ 5 min. max. / 30 min. / 5 min. max.
5 cycles
10. Salt spray test
No excessive corrosion
5% salt water solution, 48 hours
Note: Information contained in this catalog represents general requirements for this Series. Contact us for the drawings and
specifications for a specific part number shown.
* V.S.W.R. Measurement System
Measured as shown on the block diagram below.
Network Analyzer
Test Set
Test Port
Test Port Cable
D.U.T Termination
Note1: N.FL Cable assembly (plug) is measured with SMA conversion
adapters mated with N.FL plugs at both ends of a 100cm coaxial
cable harness
Note2: N.FL receptacle, which is mounted on a 50 ohms glass epoxy
board, is measured with a SMA conversion adapter.
â Materials / Finishes
âPlugs-Right Angle
Part
Shell
Female center contact
Material
Phosphor bronze
Phosphor bronze
Insulator
PBT
âReceptacle
Part
Shell
Male center contact
Insulator
Material
Phosphor bronze
Brass
LCP
Finish
Silver plated
Gold plated
Color: Black, UL94V-0
Color: Gray, UL94HB(HF type)
Finish
Silver plated
Gold plated
Color: Black, UL94V-0
2
|
▷ |