English
Language : 

HCS2-150-F Datasheet, PDF (2/3 Pages) Hirose Electric – RF Coaxial Switches (DC to 15 GHz)
140
sSpecifications
Part Number
Frequency Range
(GHz)
V.S.W.R. (Max)
DC~00.4GHz
4~00.8GHz
8~12.4GHz
12.4~0.15GHz
HCS2-150-F HCS2-111-F HCS2-110-F HCS2-140-F HCS2-121-F HCS2-120-F HCS2-131-F HCS2-130-F
DC~15
1.20
1.25
1.40
1.50
Insertion Loss (Max)
(dB)
DC~00.4GHz
0.2
4~00.8GHz
0.3
8~12.4GHz
0.4
12.4~0.15GHz
0.5
Isolation (Min)
60
(dB)
Power
15
(W)
Heat Sink Temperature
at Applicable Voltage
+50
(ç Max)
RMS Voltage Rating
300
Peak (V)
Switching Time
30
(ms)
Switching Volt Current DC9~11V DC11~14V DC11~14V DC15~19V DC18~24.5V DC18~24.5V DC24~30V DC24~30V
250mA Max 120mA Max 120mA Max 150mA Max 120mA Max 120mA Max 70mA Max 70mA Max
Durability
(Insertion/withdrawal)
30000
10000
30000
30000
10000
30000
10000
30000
Connectors
HRM-J
Type of Switch
SPDT
Operation
fail-safe
Auxiliary contact point without
with
without
without
with
without
with
without
Weight
50
(g)
qThe value of the switching current is the maximum value at 20ç.
sPrecautions
qThe HCS2 Series is of the fail safe type and designed to make contact by spring force when the drive voltage is not applied. The
application of vibrations or shocks in excess of the spring limit may cause resonance of the spring which results in a loss of contact
stability and intermittent contact.
qThe construction does not prevent the effects of humidity, pressure, or the atmosphere (i.e., gases, oils, and liquids). (Gases, depending
on type, may penetrate the spring material inside. The penetration of gases, oils, or liquids that form a film on the contacts may causes
changes of the insulation or may cause the contacts to cease to conduct.)
qThis product is not magnetically shielded and as such the attention must be paid to the following points.
(1) The plate used to mount this product should be made of non-magnetic material. (Aluminum plate is preferable.)
(2) Avoid the use of magnetic material and anything that may produce a magnetic field such as a magnet in the proximity of the switches
(roughly a 15 mm square).