HR34B-12WPA-10S-X Datasheet, PDF (10/10 Pages) Hirose Electric – Push-on Bayonet Lock Miniature Waterproof Connector

The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.
HR34B SeriesqPush-on Bayonet Lock Miniature Waterproof Connector
BReceptacle Contact Arrangement
4 pos.wire solder
10 pos.wire solder
10 pos.through hole
1
2
3
123
4567
8 9 10
note.1 View direction:Mating surface of pin insert.
note.2 mark is ground terminal.
BHandling
1. Mating
Receptacle
Plug
123
4567
8 9 10
2. Un-mating
Locking collar
B
A
Mating position alignment marks
Rotate counter-clockwise
Holding the plug by the outer shell (A) align the arrow on the plug Rotate the locking collar counter-clockwise to a full stop and un-
with the alignment mark on the receptacle and push straight in.
mate the plug from the receptacle.
BPrecautions
Center line of the connector
Alignment mark
When completely mated and locked the alignment arrow on the plug must
line-up with the center line of the connector (alignment mark on the
receptacle).
If the alignment arrow and the center line of the connectors are not aligned
(1 mm max.) re-insert the plug until they are aligned.
1 mm max.
1. When disconnecting or inserting the connector, be sure to do so after turning off the power.
2. To insert the connector, push it in until the arrow tip of the plug mating mark indicates the specified position of the diagram
below (i.e., the mating mark of the receptacle).
3. Note that the display method of the mating mark will differ depending on the receptacle.
4. To maintain the waterproof quality and cable clamp force, use a cable that is within the range of the applicable cable diameter.
5. Please consult Hirose Electric Sales for harness assembly procedure.
10