X.FL Datasheet, PDF (1/8 Pages) Hirose Electric – Low-Profile, Ultraminiature Lightweight SMT Coaxial Connectors - 0.94 or 1.2 mm Mated Height

NEW
Low-Profile, Ultraminiature Lightweight SMT Coaxial Connectors - 0.94 or 1.2 mm Mated Height
X.FL Series
●Connector mated condition
.BUFE
IFJHIU
DPNQBSJTPO
DPNQBSFE
UP
DPOWFOUJPOBM
DPNQBOZ
QSPEVDUT
X.FL-LP-040
X.FL-LP-032Ê¢09Ê£ X.FL-LPÊ¢PÊ£-068
X.FL-PR-SMT1-2
X.FL-R-SMT-1 X.FL-R-SMT-1 X.FL-R-SMT-1
'JH

■Features
1. A Low mated height of 0.94 or 1.2
mm (maximum of 1.0 or 1.3 mm)
When connected this series delivers a world class
low mated height of 1.0 or 1.3 mm (see Figure 1).
2. Minimal mounting area required
The receptacle requires a footprint of only 3.4 mm²,
which is the same footprint as our W.FL and W.
FL2 series. In addition, the same land patterns can
be used. (Note: The X.FL series has no mating
compatibility with the W.FL2 and W.FL series.)
3. Ultra lightweight
The world’s smallest and lightest class of coaxial
connectors
Receptacle: 3.2 mg
Right angle plug: 22.0 mg (068),14.4 mg (040), and 15.7 mg (032)
Plug receptacle: 5.5 mg
4. High frequency transmission
This series offers the high performance needed to
meet the requirements of many different
miniature devices, featuring a DC to 6 GHz
capacity. X.FL-LP(P)-068 supports up to 12 GHz.
5. Automatic board placement
This product is available in embossed
packaging; this allows the plug and receptacles
to be automatically mounted.
6. T h e u s e o f u l t r a - f i n e c o a x i a l
(fluorinated resin insulated) cables
The use of ultra-fine coaxial (fluorinated resin
insulated) cables on these connectors offer the
ability to complete connections in small,
confined spaces with a smooth, easy operation.
7. Simple connector mating / unmating
Dedicated tools are available to ensure that proper
mating/unmating of this connector takes place.
■Product Specifications
Ratings
Nominal characteristic impedance
Frequency range
50ø
Operating temperature range -40°C to +90°C (RH 90% or less)
DC~6GHz Storage humidity range -30°C to +70°C (RH 90% or less)
Specifications (for each plug type)
Item
X.FL-LP-040
X.FL-LP-032(09)
X.FL-LP(P)-068
X.FL-PR-SMT1-2
1. Contact
resistance
(Center) Maximum of 20 mø (Center) Maximum of 25 mø (Center) Maximum of 25 mø (Center) Maximum of 25 mø
(Outer) Maximum of 10 mø (Outer) Maximum of 25 mø (Outer) Maximum of 10 mø (Outer) Maximum of 15 mø
2. V.S.W.R. (*)
1.3 or less (DC to 3 GHz)
1.4 or less (3 to 6 GHz)
1.3 or less (DC to 3 GHz)
1.4 or less (3 to 6 GHz)
1.3 or less (DC to 3 GHz)
1.4 or less (3 to 6 GHz)
1.7 or less (6 to 12 GHz)
1.3 or less (DC to 3 GHz)
1.5 or less (3 to 6 GHz)
3. Insulation resistance
Minimum of 500 MЊ , 100 V DC
4. Withstanding voltage
200 V AC, 1 minute
*V.S.W.R. Measurement System (plug type)
The above V.S.W.R. specification values were measured using the measurement system shown below.
NetworkɹAnalyzer
TestɹSet
TestɹPort
Test Port Cable
D.U.T
Termination
Note 1:Cable type connectors were measured with SMA
conversion adapters attached to both ends of the
harness product of a suitable 100 cm cable.
Note 2:Board type connectors were mounted to a 50
glass epoxy board and measurements were
conducted with SMA conversion adapters
attached.
2014.1
1