IC13T-68D-FEJ Datasheet, PDF (1/8 Pages) Hirose Electric – FPC Connectors for CardBus PC Cards

FPC Connectors for CardBus PC Cards
IC13 Series
PC Card Standard Compliant
sFeatures
1. Thinner Equipment Designs are Possible
(1) Connections are made to the main board via the FPC ^{(*Note 1)}
which permits the PC card slot to be attached directly to the
equipment case. The main board can be located at an
arbitrary position in the thick direction of the PC card slot
which permits thinner equipment designs compared to the
on-board type.
(2) Designed so that the screw ^{(*Note 2)} heads do not protrude
from the main body when fastening to the equipment case.
*Note 1: In combination with multiple contact, 0.3 mm pitch FPC connectors of
the 80-contact type (FH16 Series)
*Note 2: When M2 screws are used
2. High Performance Ground
(1) Configured with 10 CardBus grounds for use with FPC
patterns and FPC connectors.
(2) The entire back surface of the FPC is configured with a
ground mesh pattern.
3. High Performance, Dual-End, 2-Point Push Card
Ejection Mechanism
These connectors use a dual-end, 2-point push ejection
mechanism that pushes the edge surface of the PC card
horizontally. This ejection mechanism does not place a
stressful load such as a rotational force on the PC card at the
time of card ejection and thereby achieves a high level of
reliability compared to the 1-point push ejection mechanism.
4. Long card ejection makes card removal easy
(See photograph to the right.)
sApplications
Notebook computers, PDA, etc.
Designed so that screw heads do not
protrude from main body
Card in ejected condition
A40