FH3-4S-1.25DS Datasheet, PDF (1/4 Pages) Hirose Electric – 1.25mm Pitch FPC/FFC Connector

1.25mm Pitch FPC/FFC Connector
FH3 Series
sFeatures
1. 1.25mm FPC and FFC DIP Connector
The contact pitch is 1.25mm.
2. Contact Reliability
This connector has high contact reliability for high voltage
contact.
3. Sixteen Types of Contact Numbers
This connector consists of 16 kinds of 6, 8, 9, 10, 12, 13, 14,
15, 15, 17, 18, 19, 20, 21, 22, 24, and 30 contacts.
sApplications
HDD, facsimiles, printers, VTR, etc.
sProduct Specifications
Rating
Rated Current: 1A
Operating Temperature Range:-40~+85ç (Note 1) Storage Temperature Range:-10~+60ç (Note 2)
Operating Humidity Range:Relative humidity, 90% max. Storage Humidity Range:Relative humidity, 90% max.
Rated Voltage: 200V AC
(Not dewed)
(Not dewed)
Applicable FPC
t=0.2~0.35 Tin plating
Item
Specification
Condition
1. Insulation Resistance 500Mø min.
Measured at 500V DC
2. Withstand voltage
Neither short or breakdown should occur
500V AC for 1 minute
3. Contact Resistance
20mø max.
π FPC conductor resistance included
Measured at 0.1A
Contact resistance: 40mø max.
4. Mechanical operation
No part should be broken, cracked or loosened
30 cycles
5. Vibration
No part should be broken, cracked or loosened
Frequency: 10~55Hz and full amplitude 1.50mm in 3 directions for 2 hours, respectively
6. Shock
No part should be broken, cracked or loosened
Acceleration: 490m/S2, duration: 11ms, sine half-wave: in 3 directions for 3 times, respectively
7. Moisture Resistance in Steady State Insulation resistance: 50Mø min.
Exposed to temperature 40ç and humidity 90~95% for 96 hours
5 cycles under conditions as follows;
8. Temperature Cycle No part should be broken, cracked or loosened
Temperature: -55ç¡+15~+35¡+85¡+5~+35ç
Time: 30¡5 max.¡ 30¡5 max. for 5 minutes
Note 1. Temperature rise included when energized
Note 2. This storage indicates a long-term storage state for the unused product before board mounted.
The operating temperature and humidity ranges are applied to the non-energized state after the connector has been installed
in the board.
Note 3. The above standards represent this series. The individual formal agreement should be based on the "Specification".
D6