E12LY9C-O Datasheet, PDF (5/5 Pages) HB Electronic Components – Low voltage DC operated

Hebei I.T. (Shanghai) Co., Ltd.
3. Manual Hand Soldering
LED SPECIFICATION
Place Themal Comductive Glue on the MCPCB
Place Emitter on the MCPCB
Use Soldering lron to solder the leads of Emtter within 5 seconds
. ● For prototype builds or small series production runs it possible to place and solder the emitters by hand.
. ● Solder tip temperature: 230°C max for Lead Solder and 260°C max for Lead-Free Solder.
. ● Avoiding damage to the emitter or to the MCPCB dielectric layer. Damage to the epoxy layer can cause a short
circuit in the array.
. ● Do not let the solder contact from solder pad to back-side of MCPCB. This one will cause a short circuit and
damage emitter.
www.ledz.com
5/5