M22520-2-01 Datasheet, PDF (3/5 Pages) Harwin Plc – DATAMATE HAND CRIMP TOOL

The following Power Crimp Sockets can also be crimped (when used with Positioner
ZK3609-00):
K3606-06................ Power crimp pin (18 AWG), Tin plated
K3607-T6 ............... Power crimp socket (18 AWG), Tin shell/ Tin clip
GENERAL INFORMATION
The Hand crimp tool M22520/2-01 consists of a basic hand tool, which should be used
with a positioner.
The contact is correctly crimped when the tool is free to open at the fully closed
position, i.e., when the ratchet releases. The tool cannot be opened without completing
the cycle.
TOOL PREPARATION
1. Check that the tool is in the open position. Remove the safety clip from the
positioner guide (do not discard).
2. Insert the Positioner into the positioner guide and turn it 90° in the direction
shown on the tool, until the bayonet pins lock.
3. Install the safety clip back into the positioner guide (optional).
4. Check Table 1 for the correct crimp tool setting of the wire size you wish to
crimp.
5. Remove the safety clip from the selector knob (do not discard).
6. Lift and turn the selector knob until the correct crimp tool setting is lined up with
the “Sel. No.” arrow. Lower the selector knob, ensuring the locating peg lines up
with a notch.
7. Install the safety clip back into the selector knob.
Side 2
IS-01 Issue: 2 Date: 06.09.00 C/Note: 5393