HA2840 Datasheet, PDF (3/7 Pages) Harris Corporation – 600MHz, Very High Slew Rate Operational Amplifier

HA-2840
Electrical Specifications V_SUPPLY = ±15V, R_L = 1kΩ, C_L ≤ 10pF, Unless Otherwise Specified (Continued)
HA-2840-5, -9
PARAMETER
TEST CONDITIONS
TEMP (^oC) MIN
TYP
MAX
Differential Phase (Note 7)
Harmonic Distortion (Note 8)
TRANSIENT RESPONSE (Note 5)
A_V = 10
25
A_V = 10, V_O = 2V_P-P, f = 1MHz
25
-
0.03
-
-
-79
-
Rise Time
25
-
4
-
Overshoot
25
-
20
-
Slew Rate (Notes 6, 8)
Note 3
25
550
625
-
Settling Time
10V Step to 0.1%
25
-
180
-
POWER REQUIREMENTS
Supply Current (Note 8)
Full
-
13
15
Power Supply Rejection Ratio (Note 8)
V_S = ±10V to ±20V
Full
75
90
-
NOTES:
3. R_L = 1kΩ, V_O = ±10V, 0V to ±10V for slew rate.
4. Full Power Bandwidth guaranteed based on slew rate measurement using:
5. Refer to Test Circuit section of data sheet.
FPBW = ₂-^S---_π-^l-^e--_V-^w---_P---^R-_E----^aA---^t-_K-^e-- ; (VPEAK = 10V).
6. This parameter is not tested. The limits are guaranteed based on lab characterization, and reflect lot-to-lot variation.
7. Differential gain and phase are measured with a VM700A video tester, using a NTC-7 composite VITS.
8. See “Typical Performance Curves” for more information.
Test Circuits and Waveforms
UNITS
Degrees
dBc
ns
%
V/µs
ns
mA
dB
IN
+
-
OUT
900Ω
9. V_S = ±15V.
10. A_V = +10.
11. C_L < 10pF.
100Ω
TEST CIRCUIT
INPUT
INPUT
OUTPUT
Input = 1V/Div.
Output = 5V/Div.
50ns/Div.
LARGE SIGNAL RESPONSE
3
OUTPUT
Input = 10mV/Div.
Output = 100mV/Div.
50ns/Div.
SMALL SIGNAL RESPONSE