ICL232 Datasheet, PDF (2/5 Pages) Intersil Corporation – +5V Powered, Dual RS-232 Transmitter/Receiver

ICL232
Absolute Maximum Ratings
V_CC to Ground . . . . . . . . . . . . . . . . . . . . . .(GND -0.3V) < V_CC < 6V
V+ to Ground . . . . . . . . . . . . . . . . . . . . . . . (V_CC -0.3V) < V+ < 12V
V- to Ground . . . . . . . . . . . . . . . . . . . . . . . -12V < V- < (GND +0.3V)
Input Voltages
T1_IN, T2_IN. . . . . . . . . . . . . . . . . . . . (V- -0.3V) < V_IN < (V+ +0.3V)
R1_IN, R2_IN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ±30V
Output Voltages
T1_OUT, T2_OUT . . . . . . . . . . . . (V- -0.3V) < V_TXOUT < (V+ +0.3V)
R1_OUT, R2_OUT. . . . . . . . .(GND -0.3V) < V_RXOUT < (V_CC +0.3V)
Short Circuit Duration
T1_OUT, T2_OUT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Continuous
R1_OUT, R2_OUT. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Continuous
Operating Conditions
Thermal Information
Thermal Resistance (Typical, Note 1)
θ_JA (^oC/W) θ_JC (^oC/W)
CERDIP Package . . . . . . . . . . . . . . . .
80
18
PDIP Package . . . . . . . . . . . . . . . . . . . 100
N/A
SOIC Package . . . . . . . . . . . . . . . . . . . 100
N/A
Maximum Junction Temperature
Plastic Packages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 150^oC
Ceramic Package . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 175^oC
Maximum Storage Temperature Range . . . . . . . . . .-65^oC to 150^oC
Maximum Lead Temperature (Soldering 10s) . . . . . . . . . . . . . 300^oC
Temperature Ranges
ICL232C . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .0^oC to 70^oC
ICL232I . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -40^oC to 85^oC
ICL232M . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -55^oC to 125^oC
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation
of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTE:
1. θ_JA is measured with the component mounted on an evaluation PC board in free air.
Electrical Specifications Test Conditions: V_CC = +5V ±10%, T_A = Operating Temperature Range. Test Circuit as in Figure 8
Unless Otherwise Specified
PARAMETER
TEST CONDITIONS
MIN
Transmitter Output Voltage Swing, T_OUT
T1_OUT and T2_OUT Loaded with 3kΩ
±5
to Ground
Power Supply Current, I_CC
Outputs Unloaded, T_A = 25^oC
-
T_IN, Input Logic Low, V_lL
-
T_IN, Input Logic High, V_lH
2.0
Logic Pullup Current, I_P
T1_IN, T2_IN = 0V
-
RS-232 Input Voltage Range, V_IN
-30
Receiver Input Impedance, R_IN
V_IN = ±3V
3.0
Receiver Input Low Threshold, V_lN (H-L)
V_CC = 5V, T_A = 25^oC
0.8
Receiver Input High Threshold, V_IN (L-H)
V_CC = 5V, T_A = 25^oC
-
Receiver Input Hysteresis, V_HYST
0.2
TTL/CMOS Receiver Output Voltage Low, V_OL I_OUT = 3.2mA
-
TTL/CMOS Receiver Output Voltage High, V_OH I_OUT = -1.0mA
3.5
Propagation Delay, t_PD
Instantaneous Slew Rate, SR
RS-232 to TTL
-
C_L = 10pF, R_L = 3kΩ, T_A = 25^oC
-
(Notes 2, 3)
Transition Region Slew Rate, SR_T
R_L = 3kΩ, C_L = 2500pF Measured
-
from +3V to -3V or -3V to +3V
Output Resistance, R_OUT
RS-232 Output Short Circuit Current, I_SC
NOTES:
2. Guaranteed by design.
3. See Figure 4 for definition.
V_CC = V+ = V- = 0V, V_OUT = ±2V
300
T1_OUT or T2_OUT Shorted to GND
-
TYP
MAX
UNITS
±9
±10
V
5
10
mA
-
0.8
V
-
-
V
15
200
µA
-
+30
V
5.0
7.0
kΩ
1.2
-
V
1.7
2.4
V
0.5
1.0
V
0.1
0.4
V
4.6
-
V
0.5
-
µs
-
30
V/µs
3
-
V/µs
-
-
Ω
±10
-
mA
8-50