HFDOM40KVXXX Datasheet, PDF (14/30 Pages) Hanbit Electronics Co.,Ltd – 40Pin Flash Disk Module Min.8MB ~ Max.1GB, True IDE Interface Mode, 3.3V / 5.0V Operating

HANBit
HFDOM40KVxxx
1 Set Sleep Mode
E6h or 99h
1 Stand By
E2h or 96h
1 Stand By Immediate
E0h or 94h
1 Translate Sector
87h
1 Wear Level
F5h
2 Write Buffer
E8h
2 Write Long Sector
32h or 33h
3 Write Multiple
C5h
3 WriteMultiple w/o Erase CDh
2 Write Sector(s)
30h or 31h
2 Write Sector(s) w/o Erase 38h
3 Write Verify
3Ch
-
-
-
-
D
-
-
-
-
-
D
-
-
-
-
-
D
-
-
Y
Y
Y
Y
Y
-
-
-
-
Y
-
-
-
-
--
D
-
-
-
Y
Y
Y
Y
-
Y
Y
Y
Y
Y
-
Y
Y
Y
Y
Y
-
Y
Y
Y
Y
Y
-
Y
Y
Y
Y
Y
-
Y
Y
Y
Y
Y
Definitions:
--FR = Features Register
--SC = Sector Count Register
--SN = Sector Number Register
--CY = Cylinder Registers
--DH = Card/Drive/Head Register
--LBA = Logical Block Address Mode Supported (see command descriptions for use).
--Y - The register contains a valid parameter for this command. For the Drive/Head Register Y
means both the CompactFlash Storage Card and head parameters are used; D - only the CompactFlash
Storage Card parameter is valid and not the head parameter.
Check Power Mode – 98h or E5h
Bit->
7
6
5
4
3
2
1
0
Command(7)
98h or E5h
C/D/H(6)
X
Drive
X
Cly High(5)
X
Cly Low(4)
X
Sec Num(3)
X
Sec Cnt(2)
X
Feature(1)
X
Check Power Mode
This command checks the power mode. f the CompactFlash Storage Card is in, going to, or recovering
from the sleep mode, the CompactFlash Storage Card sets BSY, sets the Sector Count Register to 00h,
clears BSY and generates an interrupt. If the CompactFlash Storage Card is in Idle mode, the
CompactFlash Storage Card sets BSY, sets the Sector Count Register to FFh, clears BSY and
generates an interrupt.
Execute Drive Diagnostic – 90h
Bit->
7
6
5
4
3
2
1
0
Command(7)
90h
C/D/H(6)
X
Drive
X
URL:www.hbe.co.kr
Rev. 1.1 (December, 2003)
14 / 14
HANBit Electronics Co., Ltd.