English
Language : 

C5964_15 Datasheet, PDF (6/7 Pages) Hamamatsu Corporation – UV to near infrared range (200 to 1000 nm) For multichannel spectrophotometry
NMOS multichannel detector head
C5964 series
Pin connection
15-pin D-sub connector (socket type)
8 7 6 5 4 3 21
Pin No.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
15 14 13 12 11 10 9
KACCC0069EA
Symbol
NC
Data video
VA1+(+15 V)
VA1-(-15 V)
VD(+5 V, P+)
Start
CLK
EOS
A.GND
A.GND
NC
D.GND(P-)
D.GND
D.GND
Trigger
Description
No connection
Analog video output signal. Positive polarity
Power supply for analog circuitry
Power supply for analog circuitry
Power supply for digital circuitry. For the thermoelectric cooler in the NMOS linear image sensor
Digital input signal to initialize the circuit
HCMOS compatible. Positive logic
The start pulse interval determines the signal storage time of the sensor.
Digital input signal to specify the circuit operation
HCMOS compatible. Operates at the rising edge
Digital output signal to indicate the end of scan of the NMOS linear image sensor
HCMOS compatible. Negative logic
Analog ground
Analog ground
No connection
Digital ground. Power supply return of the thermoelectric cooler mounted in the NMOS linear image
sensor
Digital ground
Digital ground
Digital output signal for A/D conversion
HCMOS compatible. Positive logic
Precautions for use
The C5964 series is a precision device, so use sufficient caution when handling it.
Never disassemble or modify the device as this may cause an operating failure.
Protect the device from shocks such as drops or impacts.
Avoid storing the device in high temperature and high humidity locations for long periods of time.
Never block the air vents provided on the top and side panels of this unit during operation. Blocking the air vents may cause overheating.
When connecting to other equipment, check that the electrical specifications are matched.
Never exceed the maximum ratings during operation.
Observe the following precautions to obtain the fullest performance of device.
Provide a proper shield to protect the device against external electromagnetic effects.
Use of a shield cable is recommended.
Use a power supply with minimum ripple and noise.
Pay attention to prevent extraneous light from entering the device for accurate measurements.
6