C9730DK-10 Datasheet, PDF (3/4 Pages) Hamamatsu Corporation – Large area soft X-ray imaging, high resolution

Flat panel sensor C9730DK-10
s System requirements
To operate C9730DK-10 at full performance, the following system and peripherals are required.
· PC:IBM compatible PC with USB2.0 running on Windows XP
· Power source: A. vdd = +5.0 ± 0.1 V (800 mA), D. vdd = +5.0 ± 0.1 V (300 mA)
Please use a series power supply is recommended. (Avoid using a switching power supply.) A power cable (terminated with a
JSTJ-C9-2C plug at one end and open at the other end; 2 m; see Table 1.) and an external trigger cable (terminated with an
FGG.0B.304.CLAD56 plug at one end and open at the other end; 5 m; see table 2.) comes supplied with C9730DK-10.
C9730DK-10 does not include USB cable.
The voltages described above are specified at the flat panel sensor side. The impedance of the power cable attached with the
flat panel sensor is low enough but it causes 0.1 V approx. drop. Therefore the voltage at the power source side should be set
0.1 V higher than the voltage specified above. Install a noise filter on the AC power input line to prevent surges on the AC line.
DCAM-API (Digital Camera Application Programming Interface) produced by HAMAMATSU supports C9730DK-10. The driver
software and DLL are included in DCAM-API. The latest version of the DCAM-API can be downloaded from http://
www.dcamapi.com/. DCAM-SDK which includes function manual and sample software can be provided only for OEM customer.
The USB receptacle is mini-B type. The mini-B USB cable is not attached. The earth terminal must be connected to a stable earth
point to eliminate noise from surroundings.
Table 1: Pin assignment and cable color for 9-pin power receptacle
Pin No.
Color
1
Yellow
2
Blue
3
Gray
4
Black
5
Red
6
Green
7
Purple
8
W hite
9
Brown
9-pin receptacle: DE-9PF-N made by JAE (Japan Aviation Electronics Industry, Limited)
Mating plug: JST J-C9-2C made by JST Mfg. Co., Ltd.
Signal
Digital GND
Digital GND
Analog GND
Analog GND
Analog GND
Digital +5 V
Digital +5 V
Analog +5 V
Analog +5 V
Table 2: Pin assignment and color cable for 4-pin trigger cable
Pin No.
Color
1
2
Blue
Orange
Twist pair
3
4
Green
Brown
Twist pair
4-pin receptacle: ECG. 0B. 304. CLL made by LEMO S. A.
Mating plug: FGG. 0B. 304. CLAD56 made by LEMO S. A.
Signal
TrgIn
Digital GND
TrgOut
Digital GND
s Dimensional outline (unit: mm, tolerance: ±1 mm unless otherwise noted)
18.5 31 23.5 12.5 25 12.5
14.5
CMOS FLAT PANEL SENSOR C9730DK-10
ACTIVE AREA
51.6
(1031, 1031)
(0, 0)
108
266
C1.3
Top cover material including window is carbon fiber (1.0 mm thickness).
Weight: 1.3 kg
261 *
(6 ×) M3 DEPTH 8
151 *
57.5 *
* ±0.5
KACCA0211EA
3