C9728DK-10 Datasheet, PDF (3/4 Pages) Hamamatsu Corporation – Flat panel sensor Cassette type X-ray sensor with USB 2.0 interface

Flat panel sensor C9728DK-10
s System requirements
To operate C9728DK-10 at full performance, the following system and peripherals are required.
· PC: IBM full compatible PC with USB 2.0 running on Windows XP. The south bridge of on-board Intel chip set should be ICH4
or later.
· Power source: A.vdd = +5.0 ± 0.1 V (600 mA), D.vdd = +5.0 ± 0.1 V (900 mA)
Please use a low noise series power supply. (Avoid using a switching power supply.) A pigtail power cable (terminated with a JST
J-C9-2C plug at one end and open at the other end; 2 m; see Table 1.), an trigger cable (terminated with an FGG.0B. 304. CLAD56
plug at one end and open at the other end; 5 m; see table 2.) and an earth cable (AWG 18; 4 m) come supplied with C9728DK-
10.
The voltages described above are specified at the flat panel sensor side. The impedance of the power cable attached with the flat
panel sensor is low enough but it causes 0.1 V approx. drop. Therefore the voltage at the power source side should be set 0.1 V
higher than the voltage specified above. Install a noise filter on the AC power input line to prevent surges on the AC line.
DCAM-API (Digital Camera Application Programming Interface) produced by HAMAMATSU supports C9728DK-10. The driver
software and DLL are included in DCAM-API. The latest version of the DCAM-API can be downloaded from http://www.dcamapi.com/
. DCAM-SDK which includes function manual and sample software can be provided only for OEM customer.
The USB receptacle is mini-B type. The mini-B USB cable is not attached.
The earth terminal must be connected to a stable earth point to eliminate noise from surroundings.
Table 1: Pin assignment and cable color for 9-pin power receptacle
Pin No.
Color
1
Yellow
2
Blue
3
Gray
4
Black
5
Red
6
Green
7
Purple
8
White
9
Brown
9-pin receptacle: DE-9PF-N made by JAE (Japan Aviation Electronics Industry, Limited)
Mating plug: JST J-C9-2C made by J.S.T. Mfg. Co., Ltd.
Signal
Digital GND
Digital GND
Analog GND
Analog GND
Analog GND
Digital +5 V
Digital +5 V
Analog +5 V
Analog +5 V
Table 2: Pin assignment and color cable for 4-pin trigger cable
Pin No.
Color
1
2
Blue
Orange
Twist pair
3
4
Green
Brown
Twist pair
4-pin receptacle: ECG. 0B. 304. CLL made by LEMO S. A.
Mating plug: FGG. 0B. 304. CLAD56 made by LEMO S. A.
Signal
TrgIn
Digital GND
TrgOut
Digital GND
s Dimensional outline (unit: mm, tolerance: ±1 mm unless otherwise noted)
18.5 31 23.5 12.5 25 12.5
14.5
CMOS FLAT PANEL SENSOR C9728DK-10
ACTIVE AREA
51.6
(1031, 1031)
(0, 0)
261 *
(6 ×) M3 DEPTH 8
108
266
C1.3
151 *
57.5 *
Top cover material including window is carbon fiber (1.0 mm thickness).
Weight: 1.3 kg
* ±0.5
KACCA0227EA
3