C7557_07 Datasheet, PDF (3/6 Pages) Hamamatsu Corporation – Multichannel detector head controller

Multichannel detector head controller C7557
s Operation method
1. Make connections as indicated in ➀ to ➄.
➀ LINE
Connect to the power cable.
➁ SCSI ^*4
Connect to a computer through the SCSI interface cable. When C7557 is the last unit in the SCSI
chain, plug a teminator into another SCSI port on C7557.
➂ TE CONTROL I/O Connect to the "TE CONTROL I/O" terminal on the detector head.
➃ SIGNAL I/O
Connect to the "I/O SIGNAL" terminal on the detector head.
➄ GND
When a 2-pin AC plug is used with the power cable, use this GND connector to ground the unit.
2. When all the connections are complete, turn on the power to C7557.
3. Install the dedicated softeware. (For details on the dedicated software, refer to the operation manual supplied in the package.)
*4: A terminator must be plugged into the last unit in the SCSI chain.
POWER
SIGNAL I/O
TE CONTROL I/O
TRIG.IN
RS-232C
PULSE OUT
LINE
VIDEO OUT
SCSI ID
SYNC.OUT
SCSI
FRONT VIEW
REAR VIEW
KACCC0083EC
3