S10140_11 Datasheet, PDF (12/13 Pages) Hamamatsu Corporation – Low readout noise, high resolution (pixel size: 12 ..m)

CCD area image sensor
S10140/S10141 series
Precaution for use (Electrostatic countermeasures)
O Handle these sensors with bare hands or wearing cotton gloves. In addition, wear anti-static clothing or use a wrist band with an earth ring, in
order to prevent electrostatic damage due to electrical charges from friction.
O Avoid directly placing these sensors on a work-desk or work-bench that may carry an electrostatic charge.
O Provide ground lines or ground connection with the work-Àoor, work-desk and work-bench to allow static electricity to discharge.
O Ground the tools used to handle these sensors, such as tweezers and soldering irons.
It is not always necessary to provide all the electrostatic measures stated above. Implement these measures according to the amount of damage
that occurs.
Element cooling/heating temperature incline rate
When cooling the CCD by an externally attached cooler, set the cooler operation so that the temperature gradient (rate of temperature change)
for cooling or allowing the CCD to warm back is less than 5 K/minute.
Features
Multichannel detector heads C10150, C10151
Designed for back-thinned CCD area image sensor
C10150: for non-cooled type (S10140 series)
C10151: for TE-cooled type (S10141 series)
Line binning operation/area scanning operation
Driver/amplifier circuit for low noise CCD operation
Highly stable temperature controller (C10151)
Cooling temperature: -10 ± 0.05 °C
Simple signal input operation
Compact configuration
Features
Multichannel detector head controller C7557-01
For control of multichannel detector head and data
acquisition
Easy control and data acquisition using supplied
software via USB interface
12