S7170-0909 Datasheet, PDF (1/9 Pages) Hamamatsu Corporation – CCD area image sensor 512 × 512 pixels, Back-thinned FFT-CCD

IMAGE SENSOR
CCD area image sensor
S7170-0909, S7171-0909
512 × 512 pixels, Back-thinned FFT-CCD
Hamamatsu developed Multi Pin-Phase (MPP) mode back-thinned FFT- CCDs S7170-0909, S7171-0909 specifically designed for low-light-level
detection in scientific applications. S7170-0909, S7171-0909 have sensitivity from the UV to near-IR as well as having low dark current and wide
dynamic range. Stability of the spectral response curve is also achieved for high precision measurements.
Either one-stage or two-stage thermoelectric cooler is built into the package (S7171-0909, S7172-0909). At room temperature operation, the
device can be cooled down to -10 ˚C by one-stage cooler and -30 ˚C by two-stage cooler, respectively. In addition since both the CCD chip and
the thermoelectric cooler are hermetically sealed, no dry air is required, thus allowing easy handling.
Features
l 512 × 512 pixel format
l Greater than 90 % quantum efficiency
at peak sensitivity wavelength
l Wide spectrum range
l Low readout noise
l Wide dynamic range
l MPP operation
l Non-cooled types: S7170-0909
One-stage TE-cooled types: S7171-0909
Applications
l Scientific measuring instrument
l Semiconductor inspection
l UV imaging
l Bio-photon observation
s Selection guide
Type No.
S7170-0909
Cooling
Non-cooled
Number of total pixels
532 × 520
Number of active
pixels
512 × 512
Active area
[mm (H) × mm (V)]
12.288 × 12.288
S7171-0909
One-stage
TE-cooled
532 × 520
Note) Two-stage TE-cooled type (S7172-0909) is also available.
512 × 512
12.288 × 12.288
s General ratings
Parameter
Pixel size
Number of active pixels
Vertical clock phase
Horizontal clock phase
Output circuit
Package
Built-in cooler
Window
*1: Window-less is available upon request.
S7170-0909
S7171-0909
24 (H) × 24 (V) µm
512 (H) × 512 (V)
2 phase
2 phase
One-stage MOSFET source follower
24 pin ceramic DIP (refer to dimensional outlines)
-
One-stage
Sapphire glass *¹
1