C7180_07 Datasheet, PDF (1/3 Pages) Hamamatsu Corporation – Detector head for back-thinned CCD area image sensor

IMAGE SENSOR
CCD multichannel detector head
C7180, C7181
Detector head for back-thinned CCD area image sensor
C7180 and C7181 are high-sensitivity multichannel detector heads designed for 512 × 512 pixel, back-thinned FFT-CCD area image sensors
(S7170-0909, S7171-0909). C7180 works with non-cooled type back-thinned CCD area image sensor (S7170-0909) and C7181 with one-stage
thermoelectrically cooled type (S7171-0909). Both C7180 and C7181 have a low noise driver/amplifier circuit that operates the CCD image
sensor by input of simple external signals.
C7181 also includes a highly stable temperature controller that cools the sensor to a preset temperature level (Ts= -10 ˚C) as soon as the power
is turned on. If the cooler fails and causes internal circuitry to overheat, the built-in protection circuit automatically turns off the power. Despite its
compact size, the housing configuration is designed for good heat dissipation, and threaded mounting holes on the front panel allow connections
to other devices such as monochrometers. Controller for multichannel detector head C7557 is also available. The software supplied with the
C7557 allows easy control of the multichannel detector head and data acquisition.
Features
Applications
l Designed for back-thinned CCD area image sensor *1
C7180: for non-cooled type (S7170-0909)
C7181: for TE-cooled type (S7171-0909)
l Choice of line binning operation*²/area scanning operation
l Built-in driver circuit
l Highly stable temperature controller (C7181)
Cooling temperature: fixed at Ts= -10 ± 0.05 ˚C
l Operates with simple input signals
l High UV sensitivity and high quantum efficiency
l Compact configuration
l Scientific measurement instrument
l Semiconductor inspection
l UV imaging
l Biophoton observation
s Selection guide
The table below shows CCD area image sensors applicable for C7180, C7181.
Since C7180, C7181 do not include a CCD area image sensor, so select the desired sensor and order it separately.
CCD area image sensor
Type No.
Type No.
Cooling
Number of pixels
Number of
active pixels
Active area
[mm (H) × mm (V)]
C7180
S7170-0909
Non-cooled
532 × 520
512 × 512
12.288 × 12.288
C7181
S7171-0909
One-stage
TE-cooled
532 × 520
512 × 512
12.288 × 12.288
Note) Multichannel detector head C7182 designed for 512 × 512 pixel, two-stage TE-cooled CCD area image sensor (S7172-0909) is
also available.
*1: In normal CCD image sensors that receive light from the front surface, the active area is covered with transparent electrodes for
charge transfer. These electrodes cut off UV radiation incident on the image sensor and also reduce the quantum efficiency. In
contrast, back-thinned CCD image sensors have a unique structure in which the back of the active area is finely ground to allow
light to enter from the back surface. This structure ensures high UV sensitivity and quantum efficiency because incident light need
not pass through the transparent electrodes.
*2: The FFT-CCD was originally designed as a two-dimensional image sensor. However, it can be operated like a linear image sensor
having a large active area by transferring all the pixel signals in the vertical direction to the horizontal register (this is referred to as
line binning).
1